Poe Clock Quick Setup Guide

Transcript

1. Remove contents from packaging. www.css-timemachines.com Precision Clocks “When you absolutely can't afford a time shift” Quick Setup Guide Time Machines 6030 S.58th Street, Suite C Lincoln, NE 68516 402-261-8688 Full Owners Manual is available at http://www.css-timemachines.com ✔ ✔ ✔ ✔ Clock Anchor and Screws Quick Setup guide Template for wall mounting (other side of this guide) 2. To power up the clock connect Network Cable to PoE switch or injector and to the rear panel. 1. Wait 20-40 seconds until the clock shows time 2. The default source for time is: nist1-chi.ustiming.org 3. To set Time Zone, push the button once to adjust time by -1 (minus) 1. The default time is Eastern Standard Time (EST) 2. Each push of the button will adjust the time by -1 hour 1. For example, push the button twice for Mountain Standard Time 4. More adjustments can be made by using your web browser 1. Push the button twice (rapidly) and the default DHCP Served IP address will scroll across the display. 2. Point your web browser to the default address to make other adjustments. For Example, URL:http://10.10.0.100 5. To set factory defaults hold the button down when the clock is powered on. If done correctly “888” will scroll across the display. 6. For more detailed instructions on the clock go to www.csstimemachines.com to download the full manual. (This form is also available for download) ₵→○ 1. Remove contents from packaging. Direct Mounting Template Tools Needed for Installation: • • • • Hammer Drill ¼” Drill Bit Screwdriver 2. 3. 4. 5. 6. 7. 8. ✔ Clock ✔ Screws ✔ Anchors For all clocks use the following instructions to install the clock. If you have the TM460 the mounting hole spacing is 16” on center. All other clock mounting locations will match up to the 12.542” spacing. Drill two 1/4” holes 12.542” apart and insert wall anchors. On this page, the circles at the corners can be used to quickly locate mounting holes. Verify the spacing of the holes on this page before using the template with a tape measure. It is possible that the image was scaled while printing. Be sure to level the holes so the clock hangs square. Insert screws leaving a 1/16” gap between the head and the mounting surface. Connect Network Cable (customer supplied) to PoE switch or injector. Push button located on the back of the clock until the correct time is displayed. Place clock on wall. It is understood that the mounting hardware included with the clock may not be appropriate for all installations. It is the responsibility of the person installing the clock to determine if the mounting hardware is sufficient to secure the clock to a permanent structure. The included hardware is meant to suggest a method of attachment. Please comply with local building codes and regulations. ○←₵