Transcript
Power over Ethernet (PoE) Splitter TPE-102S (b1)
TRENDnet's TPE-102S Power over Ethernet Splitter provides an innovative and cost effective solution to a variety of Ethernet devices such as VoIP phones or Wireless Access Points. Reduce costs by using existing CAT5 cable to deliver both power and data where power source is difficult to obtain.
FEATURES
• IEEE 802.3af Power over Ethernet (PoE) Standard Compliant • Support up to 11W at 5V DC or 12W at 12V DC • Converts Non-PoE devices with Power Over Ethernet Support • Advanced Auto-Sensing Algorithm enables the ability to draw power from 802.3af PSE (Power Source Equipment) Devices • High Safety Standards with Short Circuit Protection • Supports Power Detection and Classification • Auto Disconnection for Over Voltage or Under Voltage Situation • 5-Year Warranty
TEW-503PI (07-28-2005)
TPE-102S (b1) rev:11.07.2005
Power over Ethernet (PoE) Splitter TPE-102S (b1) SPECIFICATIONS Hardware Standards
• IEEE 802.3 10Base-T
• IEEE802.3u 100Base-TX
• IEEE 802.3af Power over Ethernet
• 10Mbps: Cat 3,4,5 Unshielded/Shielded/Screened Cable
Network Media
• 100Mbps: Cat 5, 5E, 6 Unshielded/Shielded/Screened Cable
Protocol
• CSMA/CD
Topology
• Star • 1 x PoE-IN Port (Data + Power)
Ports
• 1 x Data-OUT Port (Data only)
Switch
• Switch between 5V and 12V
Power
• DC Output 5V/2.2A or 12V/1A
Jumper Cable
• 2.5mm / 0.1” Diameter on the Connector (Center Positive) • Power In: 48V (Green)
Diagnostic LEDs
• Power Out: 5V (Green) / 12V (Amber)
Power Consumption
• 15.4 watts (max) • Operating: 0°~ 40°C (32°F~ 104°F)
Temperature
• Storage: -10°~ 70°C (14°F~ 158°F)
Humidity
• 10%- 90% (non-condensing)
Dimensions (LxWxH)
• 87 x 85 x 24mm (3.425 x 3.35 x 0.95 inches) (L x W x H)
Weights
• 156g (0.35 lb)
Certification
• FCC, CE
NETWORKING SOLUTIONS PoE Ports
PACKAGE CONTENTS • Multi-Language User's Guide
Ethernet Data
48VDC Power + Ethernet Data 16-Port PoE and 10/100Mbps Web Smart Switch (TPE-S88)
Power
• Power Jumper Cable • Cat.5 Cable (60cm/23.6inches)
Powered Device which uses 5V or 12V Power Input (Wireless AP, Camera, etc.)
Power Ethernet Data 48VDC Power + Ethernet Data
16-Port PoE and 10/100Mbps Web Smart Switch (TPE-S88)
• TPE-102S
Power over Ethernet Splitter (TPE-102S)
RELATED PRODUCTS TPE-101I
Power over Ethernet (PoE) Injector
TPE-S88
16-Port 10/100Mbps Web Smart PoE Switch
Ethernet Ports
Ethernet Data
Power over Ethernet Injector (TPE-101I)
48VDC Power 48VDC Power + Ethernet Data
ORDERING INFORMATION
Ethernet Data
Power Jack
Power
Power over Ethernet Splitter (TPE-102S) 48V DC Power Power Ethernet Data 48VDC Power + Ethernet Data
Powered Device which uses 5V or 12V Power Input (Wireless AP, Camera, etc.)
3135 Kashiwa Street,Torrance, CA 90505 USA Tel: 1-888-777-1550 Fax: 310-891-1111 Web: www.trendnet.com Email:
[email protected]
To Order Please Call:
1-888-326-6061 TRENDnet is a registered trademark. Other Brands and product names are trademarks of their respective holders. Information provided in this document pertain to TRENDnet products and is subject to change at any time, without notice. For the most recent product information please visit http://www.trendnet.com. Copyright © TRENDnet. All Rights Reserved.
