Transcript
VANSON ELECTRONICS(SHANGHAI) INC. 5999, Huyi Highway, Waigang Town, Jiading
[email protected] Shanghai, CHINA. tel. 02.3361.1626
TEL: +86-21-59585999
02.2626.1009E-MAIL: www.elitaliaweb.it FAX:fax +86-21-59585678
[email protected]
1.
MODEL:
16CCG04XL
2
Dimension
Outer Diameter Φ16mm. Height
Refer to Fig 1
Materials
DYNAMIC
SPEAKER
mm. Weight 2.7gram
3.
Magnet
NdFeB
4.
Impedance
5.
Power Rating
Normal 1.5
6
Lowest Resonant Frequency
550± 20% Hz at 1.0V measured by SUNLILAB® 7117C
7.
Output Sound Pressure
80±
(S.P.L.)
At 800, 1000, 1200 ,1500 HZ Average
8.
Frequency Range
400 ~
9.
Distortion
10.
Abnormal Sound Test
Must be Normal Tested By 2.45 Volts.
11.
Load Test
Pink Noise With 2.45Volts(RMS.)24hrs.
12
Storage Temperature
- 25ºC ~ + 65ºC
13.
Operating
- 20ºC ~ + 60ºC
±
4Ω
15 % W.
At
1000
Maximum 2.0
Hz. W.
3 db / 1.0Watt . 0.5Meter, Measured by B&K Type 2012
20,000 Hz. Average SPL -10db
Refer to Fig. 2
5% Maximum at 1K Hz 1.0 W.
Temperature
PRELIMINARY
Sine Wave.
Fig.1
14.Frequency Response Curve. 14.1 Sound
Speaker Pressure Level(SPL) :80± 3dB 1.0W/0.5M at (800,1k,1.2k,1.5k) AV
INPUT: MIC DIST: BAFFLE:
1.0W 0.5M IEC6028-5
PRELIMINARY Fig.2
15.Environment 15.1
Test
Environment test – High temperature.
After exposure the speaker in the + 65± 3 °C chamber for 24 hours, then leave the speaker at room temperature for 2 hour, the SPL should not deviate by ± 3 db, compare with pre-test measurement. 15.2
Environment test - Low temperature.
After exposure the speaker in the − 25 ± 3 °C chamber for24 hours, then leave the speaker at room temperature for 2 hour, the SPL should not deviate by ± 3 db, compare with pre-test measurement. 15.3
Environment test-Temperature cycle.
After exposure the speaker in the chamber, temperature cycle setting as below shows, SPL should not Deviate by ± 4db,compare with pre-test measurement.
+65°C
1 Hour Room Temperature 10sec +25°C Start 1 Hour
10 sec To start
Total 4 cycles
1 Hour -25°C
15.4
Environment test – Humidity.
After exposure the speaker in the + 40 ±3 ℃, relative humidity 90% ∼95% chamber for 24 hours, then leave the speaker at room temperature for 6 hours, the SPL should not deviate by ±3db, compare with pre-test measurement.
PRELIMINARY
tel. 02.3361.1626 fax 02.2626.1009
[email protected] www.elitaliaweb.it
tel. 02.3361.1626 fax 02.2626.1009
[email protected] www.elitaliaweb.it
VANSONIC ENTERPRISE CO.,LTD. 8F., No7, Lane16, Sec2, Szechwan Road, Panchiao, Taipei Hsien, TAIWAN. E-mail:
[email protected] Homepage:http://www.veco.com.tw tel. 02.3361.1626
[email protected] fax 02.2626.1009 www.elitaliaweb.it TEL: +886-2-962 6335 FAX: +886-2-962 5220
1.
MODEL:
20VS08PL
2.
Dimension
Outer Diameter Height
DYNAMIC
SPEAKER
19.5x13.5 mm.
Refer to Fig 1
mm. Weight 2.2
Grams.
3.
Magnet
Materials
NdFeB
4.
Impedance
8 Ω
5.
Power Rating
Normal
6
Lowest Resonant Frequency
900 ± 20% Hz at 1.0V measured by SUNLILAB® 7117C
7.
Output Sound Pressure
80 ±
3 db /
(S.P.L.)
At
800,
8.
Frequency Range
500
9.
Distortion
5 % Maximum at 1500 Hz 1.0 W.
10.
Abnormal Sound Test
Must be Normal Tested By 2.83 Volts.
11.
Load Test
12
Storage Temperature
- 25℃ ~ +70℃
13.
Operating
- 20℃ ~ +60℃
±
~
15 %
1.0
W.
At
1000
Maximum
1.5
Hz. W.
1.0Watt . 0.5Meter, Measured by B&K Type 2012
1000, 1200, 1500,
20,000+ Hz.
HZ Average
Average SPL -10db
Refer to Fig. 2
Sine Wave.
Pink noise with HPF(High Pass Filter 235HZ-3db-11db/Oct)2.83Volts(RMS.)24hrs.
Temperature
Fig.1
14.Frequency Response Curve. 14.1 Speaker Sound Pressure Level(SPL) :80±3dB 1.0W/0.5M at (800,1k,1.2k,1.5k) AV
INPUT: MIC DIST: BAFFLE:
1.0W 0.5M IEC6028-5
Fig.2
15.Environment Test 15.1
Environment test – High temperature.
After exposure the speaker in the + 70± 3 °C chamber for 24 hours, then leave the speaker at room temperature for 1 hour, the SPL should not deviate by ± 3 db, compare with pre-test measurement. 15.2
Environment test - Low temperature.
After exposure the speaker in the − 25 ± 3 °C chamber for 24 hours, then leave the speaker at room temperature for 1 hour, the SPL should not deviate by ± 3 db, compare with pre-test measurement. 15.3
Environment test-Temperature cycle.
After exposure the speaker in the chamber, temperature cycle setting as below shows, SPL should not Deviate by ±4db,compare with pre-test measurement.
+70°C
1 Hour Room Temperature 10set +25°C Start 1 Hour
10 set To start
Total 4 cycles
1 Hour -25°C
15.4
Environment test – Humidity.
After exposure the speaker in the + 40 ± 3 ℃, relative humidity 90% ∼95% chamber for 24 hours, then leave the speaker at room temperature for 6 hours, the SPL should not deviate by ±3db, compare with pre-test measurement.
0.1
Vansonic Enterprise CO.,Ltd. 紘立企業 E-MAIL:
[email protected] TEL:+886-2-29626335 FAX:+886-2-29625220
0.1
0.2 0.2
Title: ASM20VSPL
框體更改為完全跑道形
VANSONIC ENTERPRISE CO.,LTD.
8F., No7, Lane16, Sec2, Szechwan Road, Panchiao, Taipei Hsien, TAIWAN. E-mail:
[email protected] Homepage:http://www.veco.com.tw tel. 02.3361.1626
[email protected] TEL: +886-2-962fax 633502.2626.1009 FAX: +886-2-962 5220 www.elitaliaweb.it
1.
MODEL:
2.
Dimension
P20VS08P-3 Outer Diameter Height
3.
Magnet
4.
Impedance
5.
Power
6
Lowest Resonant Frequency
7.
Output
8 Ω
Sound
700 ± 80±
(S.P.L.)
At
8.
Frequency Range
500
9.
Distortion
10.
Abnormal
11.
Load
12
Storage
13.
Operating
3
15
20%
Test
Test
mm. mm.
Weight
db
/
2.2
Grams.
1000
Maximum
Hz. 1.5
W.
at 1.0V measured by SUNLILAB® 7117C
1.0Watt . 0.5Meter, Measured by B&K Type 2012 1000, 1200,
20,000+
Must be Normal
At
W. Hz
5 % Maximum Sound
%
1.0
800, ~
SPEAKER
NdFeB ±
Normal
Pressure
19.5x13.5
Refer to Fig 1
Materials
Rating
DYNAMIC
1500,
HZ
Average
Hz. Average SPL -10db
at 1500
Refer to Fig. 2
Hz 1.0W.
Tested By 2.83 Volts.
Sine
Wave.
White Noise 2.83Volts(RMS.) 24hrs.
Temperature Temperature
- 25℃ ~
+70℃
- 20℃ ~
+60℃
Fig.1
This confidential document is VANSON ENTERPRISE CO.,LTD
property and may not be copied or circulated without permission
14.Frequency Response Curve. 14.1 Speaker Sound Pressure Level(SPL) :80± 3dB 1.0W/0.5M at (800,1k,1.2k,1.5k) AV
INPUT: MIC DIST: BAFFLE:
1.0W 0.5M IEC6028-5
Fig.2
This confidential document is VANSON ENTERPRISE CO.,LTD
property and may not be copied or circulated without permission
15.Environment 15.1
Test
Environment test – High temperature.
After exposure the speaker in the + 70± 3 °C chamber for 24 hours, then leave the speaker at room temperature for 1 hour, the SPL should not deviate by ± 3 db, compare with pre-test measurement. 15.2
Environment test - Low temperature.
After exposure the speaker in the − 25 ± 3 °C chamber for 24 hours, then leave the speaker at room temperature for 1 hour, the SPL should not deviate by ± 3 db, compare with pre-test measurement. 15.3
Environment test-Temperature cycle.
After exposure the speaker in the chamber, temperature cycle setting as below shows, SPL should not Deviate by ± 4db,compare with pre-test measurement.
+70°C
1 Hour Room Temperature 10set +25°C Start 1 Hour
10 set To start
Total 4 cycles
1 Hour -25°C
15.4
Environment test – Humidity.
After exposure the speaker in the + 40 ±3 ℃, relative humidity 90% ∼95% chamber for 24 hours, then leave the speaker at room temperature for 6 hours, the SPL should not deviate by ±3db, compare with pre-test measurement.
This confidential document is VANSON ENTERPRISE CO.,LTD
property and may not be copied or circulated without permission
8F.,No.7,Lane 16, Sec.2, Szechwan Road, Panchiao, Taipei Hsien, TAIWAN. tel. 02.3361.1626
[email protected]
02.2626.1009E-MAIL:
[email protected] www.elitaliaweb.it FAX:fax +866-2-29625220
TEL: +866-2-29626335 1.
MODEL:
2.
Dimension
P19RE08 Outer Diameter Height
19
mm.
Baffle Opening
Refer to Drawing. Rare Earth
Weight
5.4
Magnet
Materials
4
Nominal Impedance
8
5.
Power Rating
Normal
6.
Lowest Resonant Frequency
450
7.
Output Sound Pressure Lever
78
(S.P.L.)
Average at
8.
Frequency Range
250
9.
Distortion
5
10.
Abnormal Sound Test
Must Be Normal Tested By
11.
Load Test
White Noise With Weighted Filter
12.
Polarity
Diaphragm shall move Forward when Apply a Positive DC.
±
15
1.5
Size
Grams.
3.
Ω
.
17.4 mm.
%
~ %
At
W.
Maximum
± ±
11.2 x 2.5
20 3
db 1000,
15000 Maximum At
mm.
1000
Hz.
2.5
W.
%
Hz.
1.0 Watt ． 0.5 Meter.
/
1200,
1500,
Hz.
2000
Hz.
Average S P L - 10 db. 1000 4.0
Hz. Volts.
1
W. Sine Wave.
4.0 Volts.(RMS)
24 Hrs.
Current to the "+" or "Marked" Terminal.
Unit : mm
Housing Material : ABS F:\SPEC\THIN\19RE\19RE08.DWG
