Prima P5 Monopointjbox/remote Transformer

Transcript

2 Mounting bracket assembly Mount bracket assembly to j-box with provided machine screws. Drywall anchors are also provided for alternative mounting. Ensure that threads of the small screws are pointing downward. 3 Pull 12V leads from remote transformer from the j-box through the center hole of the mounting bracket. Mounting Screws Main canopy plate Small screws should point downward For stem suspended fixtures go to step 4. Screw caps Connect the ground wire to the jbox Feed fixture socket wires from stem through the center hole of the canopy. Thread the stem into the coupler until it is secure. 4 5 Connect the socket leads to the 12V leads from the j-box. Place all wiring neatly inside the j-box opening. Raise the canopy up to the mounting plate so that the small screws poke through the small screw holes on the canopy plate. 6 For cable suspended fixtures skip to step 7. Secure the canopy plate to the mounting plate / j-box with the two included screw caps. Tighten by hand until the plate is flush against the mounting surface. Go to step 11. 7 Determine length of pendant wire and add 6” for wire connections. Cut the wire to length. 8 !
#

!"##
 !
#
 !
 #!
!$!
" 10 Secure the canopy plate to the mounting plate / j-box with the two included screw caps. Tighten by hand until the plate is flush against the mounting surface. 11 9 Connect the socket leads to the 12V leads from the j-box. Place all wiring neatly inside the j-box opening. Raise the canopy up to the mounting plate so that the small screws poke through the small screw holes on the canopy plate. CAUTION Be sure to cut the pendant cable to size and discard any extra cable. Do not try to place extra cable slack inside of the canopy. Extra wire leads in the canopy will create overheating and resistance problem over time. Canopy installation is now Always disconnect power prior to installation or maintenance. Monopoint with stem suspension Monopoint with cable suspension 13615 Marquardt Ave. Santa Fe Springs, CA 90670 Ph. 562-407-3079 . Fx. 562-407-3069 www.primalighting.com Stems and pendant wires are included with fixtures and are not part of the 65 canopy box contents. Always use dedicated breaker/branch circuit line for Prima low voltage system. Do not mix with fluorescent lighting system on the same circuit. Follow all local and national electrical codes. For assistance please call Prima Customer Service at 562-407-3079 !

" !
" Feed the pendant wire through the cable holder. Thread the cable holder into the center hole of the canopy. Place the clear protective sleeve through the cable holder and tighten the set screw to secure the cable. Prima P5 Monopoint 
Disassemble canopy as shown 1 jbox/remote transformer canopy installation instructions
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for fixtures. Prima is not responsible for any fixture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties are void if Prima transformers are not used. Prima’s catalogs provide general information and suggestions for proper dimmer usage. Please consult our customer service department with any questions regarding dimmer specifics. Prima is not responsible for any damage caused by improper dimmer specification and usage. Use only qualified electrician for installation. Adhere to all local and national electrical codes prior to installation. Rev.090214