Primo72_-_architect_guide

Transcript

PRIMO72 Specifications Please consult the manufacturer’s installation manual for all details and requirements before making a final design layout decision. MODEL PRIMO72 HEIGHT FRONT WIDTH FRONT WIDTH BACK WIDTH PRIMO72 72" Direct Vent Gas Fireplace BACK WIDTH HEIGHT Actual Actual Framing Framing Actual Actual Framing Framing Actual Actual 83-1/2 84-1/4 83-1/2 84-1/4 30-9/16 DEPTH DEPTH VIEWING AREA GLASS SIZE Framing Actual Actual Framing* Framing Framing 48 17-3/16 83-1/2" [2121] 17-3/16" [437] 8-5/8" [219] 18-1/8" [460] 18-1/4 * Framing depth will change if installing PVLP-SLP with a minimum vent configuration. Refer to install manual for details. Ø8" [203] CENTERED ON APPLIANCE Top ELECTRICAL ACCESS GAS ACCESS 13-3/8" [340] 23-13/16" [605] 9-3/8" [238] 8-1/4" [210] 3-7/16" [87] 75-1/16" [1907] 84-15/16" [2157] Front 30-9/16" [776] 2-5/16" [59] 4" [102] 7-11/16" [195] 2-13/16" [71] Left Additional information can be found online at www.heatnglo.com 39-1/2" [1003] 71-1/2 x 12-1/2 *44-3/4" [1137] 37" [940] 2-1/16" [52] *Minimum Vent Height (using SLP90) Right Finishing Dimensions PRIMO72 FINISHED OPENING DIMENSIONS NOTE: Sheetrock (1/2") may be installed up to appliance opening. WALL (1/2" SHEETROCK) 22-3/4" [579] 13-3/8" [340] 9-3/8" [238] 75" [1905] = 1/2" SHEET ROCK = APPLIANCE OPENING Clean Face Finish (Black Glass Interior) NOTE: Sheetrock (1/2") may be installed up to appliance opening. WALL (1/2" SHEETROCK) 3-3/4" [82] 27-11/16" [703] 11-13/16" [300] 1-1/4" [32] 2-1/2" [64] 1/2" 2-1/2" [13] [64] 23-13/16" [605] 9-7/8" [251] 3-7/8" [98] 70-1/16" [1780] 82" [2083] = 1/2" SHEETROCK = APPLIANCE OPENING = GRANITE SURROUND (Installed on top of 1/2" sheetrock) Black Granite Surround Finish (Black Glass Interior) Specifications PRIMO72 Framing Dimension Appliance Location 35-1/4" [895] 1" [25] DVP Pipe: 10" [254] SLP Pipe: 9" [229] 29-3/4" [756] Note* 84-1/4" [2139] 1" [25] 84-1/4" [2139] 88" [2235] Note* 124-3/8" [3159] 84-1/4" [2139] HEADER DEPTH** 48" [1219] 36" [914] 1" [25] 84-1/4" [2139] ****18-1/4" 84-1/4" [464] [2140] Note* * Note 12-1/2" if using PVLP-SLP plush one SLP elbow. This is the minimum vent configuration and is composed of the factory-installed 6" DVP component, DVP-2SLP converter, SLP90 elbow and PVLP-SLP termination cap. See inset to right DVP-2SL SLP90 * Adjust framing dimensions for interior sheathing (such as sheetrock) ** Header depth not to exceed 3-1/2" *** If appliance is installed off of floor, maintain required clearances to combustibles. Construct platform in accordance with local building codes. **** See location diagram at top of page for PVLP-SLP minimum horizontal footprint. Rough opening depth will change if installing PVLP-SLP with minimum vent configuration. 6" DVP MANTEL PROJECTIONS 1/2" SHEETROCK/ COMBUSTIBLE FACING MATERIAL Clearances to Combustibles TO CEILING All measurements in inches 6 4 11 9 14 Appliance may be installed off the floor*** MEASURE FROM TOP OF FIREPLACE OPENING 31 31" [787] 12 0" 17 *MEASUREMENT FROM BOTTOM OF FIREPLACE TO CEILING 36" [914] *53-3/4" [1365] 0" MEASUREMENTS FROM TOP EDGE OF THE OPENING 1" [25] Combustible or Non-Combustible 1" [25] MANTEL leg/wall PROJECTIONS - Wall Penetration extending past the face of the fireplace DO NOT PACK WITH INSULATION OR OTHER MATERIAL Note : Clearance from opening to perpendicular wall. 13" * 10" 44-1/4" [1124] 13" TOP VIEW FIREPLACE 1/2" Sheetrock/Combustible facing material OPENING 10" 4-1/2" MINIMUM Shows minimum vertical vented PVLP-SLP: Factory installed 6" DVP pipe, SLP90 and included DVP-2SL. 4-1/2" MAXIMUM UNLIMITED MANTEL LEG OR PERPENDICULAR WALL Acceptable on both sides of opening Combustible or Non-combustible PRODUCT LISTING CODES US ANSI Z21.50-2014 CAN CSA 2.22-2014 UL307B Product information provided is not complete and is subject to change without notice. Product installation must adhere strictly to instructions accompanying product to avoid risk of fire and potential injury. Additional information can be found online at www.heatnglo.com Web: heatnglo.com Phone: (888) 427-3973 (952) 985-6000 E-mail: infoheatnglo.com GS/HNG/PRIMO72_0315