Preview only show first 10 pages with watermark. For full document please download

Procedure For Switching From The Eveready 2744n Socket Type

   EMBED


Share

Transcript

1-800-383-7323 / USA - CANADA + 44 (0) 208 920 2306 / EUROPE www.energizer.com Procedure for switching from the Eveready 2744N socket type battery to the Eveready 510S or Energizer 528 screw terminal batteries… Parts needed: Two insulated ring tongue terminals for a number 10 stud. Tools needed: Wire cutters, wire strippers, crimping tool (pliers) Procedure: The plug on the alarm that attaches to the battery has a large post and a small post. The larger post is the positive connection. Cut the wire going to the larger post close to the plug. Strip about a quarter inch of the insulation from this wire and crimp on the insulated terminal. Attach this positive lead to the screw post on the 510S battery marked (+). Cut the wire going to the smaller post close to the plug. Strip about a quarter inch of the insulation from this wire and crimp on the insulated terminal. Attach this negative lead to the screw post on the 510S battery marked (-). You may wish to label the wires with polarity markings (using masking tape) for future battery changes. ©Energizer – All Rights Reserved Page 1 of 1