Prodigy One.2 Installation Manual

Transcript

Prodigy One.2 TD-CADICTS-KIT Installation Manual Contacts www.intraphex.com [email protected] Support: 810.355.2266 Fax: 810-735-0175 Contents  Dash Pad Bracket  AV input Cable  Prodigy One.2  4 Pin Touch Cable  Monitor  Multi Display PCB  Prodigy One Data Cable  CTS Radio T-Harness & Connectors   Bag of Screws & Clips Stereo Aux in Cable Remove center console trim bezels. use hook tool to release panel from rear. Place panels in safe location to assure they don’t get scratched. Remove gear selector trim bezel. Use hook tool to release panel from rear. Place panel in a safe location. Place shifter into “Neutral” (fig A), pull gear selector trim bezel away from radio dash bezel (fig B), Remove two 7mm screws at the lower left and right of the radio dash bezel (fig c). Remove shown plastic trim. Use hook too to pull from noted area. Remove shown plastic trim. Use hook tool to pull from noted area. Use caution not to break plastic tabs. Remove radio dash bezel. Use caution and unplug all connections from back of panel. Remove four 7mm screws from front panel of disc changer. Remove changer assembly and unplug all plugs from rear. Install INTRAPHEX supplied “T-harness”, route wires as necessary to ensure that changer assembly can be installed back into location. Plug male end of INTRAPHEX supplied “T-harness” into rear of changer assembly and reinstall antenna plugs. Replace changer assembly and re-install four 7mm screws. Please refer to wiring diagram in back of manual for reference Connect 12 volt acc wire. Use Multi-meter to test. Located at BCM, green plug PIN 6, pink wire. Insert INTRAPHEX supplied T-nuts into empty locations shown. Next we will remove the OEM radio LCD, and preset buttons. Remove eight #1 screws securing the panel in place. Gently pull the radio lcd away from dash bezel. Remove four remaining #1 screws from lcd assembly Remove preset buttons from lcd. Remove two #1 screws. Separate buttons from bezel. Add buttons to INTRAPHEX supplied trim bezel, route wires accordingly. Replace two #1 screws. Replace six #1 screws to affix INTRAPHEX supplied trim bezel to the radio panel. Replace preset button plug. Replace clock harness with Intraphex supplied harness for dimming feature. Assembled dash panel with INTRAPHEX supplied bezel. Factory dash pad. Remove t-10 torx screws to separate two pieces. Align dash pad with INTRAPHEX supplied monitor bracket. Use provided screws to attach dash pad to bracket. Assembled dash pad bracket. Attach dash pad bracket to monitor assemble using INTRAPHEX provided screws. Long screws go in back of monitor and short ones go in side of monitor. Steps 31 and 32 can be done after car is re-assembled if you find it easier. With monitor assembly in the up position install two black INTRAPHEX provided dash pad bracket rear set screws. Steps 31 and 32 can be done after car is re-assembled if you find it easier. Assembled monitor assembly Install INTRAPHEX provided harnesses into monitor assembly. Route cables accordingly and install monitor assembly into dash. Use INTRAPHEX provided screws to secure into dash. Plug in the two plugs from the preset button panel. Replace radio control panel. Replace two 7mm screws. Replace shifter trim bezel. Replace dash trim. Replace dash trim. Replace center console trim bezel SPEAKER A/V input (use AUX on radio) For CTS only For SRX only Camera Input Ignition (pin 6, pink @ green plug in BCM Reverse (pin 3, lt green @ grey plug in BCM ***NOTE*** Please be sure to set the dip switches for video input according to the chart. Not setting the dip switches correctly may render the prodigy one.2 or the video one inputs inoperative. Scan the QR code above to see a short video on the operation of the Cadillac PRODIGY ONE.2 kit.