Transcript
Instant water heater MCX SMARTRONIC The clever way to heat water for handwashing
®
Electronic instant water heater MCX SMARTRONIC ®
Energy efficiency for handwashing
The electronic instant water heater MCX SMARTRONIC® is the efficient way of supplying hot water to the handwash basin. The small appliance is installed under the basin and heats the water directly as it flows through. It switches on automatically as soon as the tap is turned on and switches off as soon as the tap is turned off. The intelligent electronics controls the necessary heating power to heat the water to the desired temperature. The user can preselect the maximum outlet temperature (35 °C, 38 °C or 45 °C) at the touch of a button on the appliance. Inlet pressure and temperature variations are surely compensated.
+
3
The new top of the range appliance on the handwash basin:
Progressively equipped like no other in its class
Wall bracket The wall bracket gives the rear of the appliance a neat finish. Designed for easy push-on installation without having to open up the appliance. Removable rating plate cover Behind the cover you can access the main hood screw and water flow adjustment. Coloured LEDs The selected temperature is indicated by discreet LED lights that also act as an operating and diagnostic display. Control panel with sensor button The desired maximum outlet temperature can be selected at the touch of a button: ECO (35 °C), COMFORT (38 °C) or MAX (45 °C).
5
Energy efficiency comparison
So economical the electronic instant water heater
22 kWh
–85%
56 kWh effective heat
91 kWh waste heat
The electronic instant water heater only heats the water when it is needed – right at the point of use. This avoids energy and water losses that inevitably occur with long pipe runs in a central hot water supply. The appliance also has many advantages compared to decentralised small storage water heaters. Warm water flows as long as desired. Because the water is not preheated, this avoids the consumption of standby power as well as water losses through expansion drops from the tap. Additional water savings are achieved because the flow rate is set at an economical level. Running costs of up to 60 euros per year can be saved. Energy consumption (kWh/year) in the washroom of an office building for ten lots of hand washing a day. Source: Appliance efficiency comparison, CLAGE GmbH
In addition, the energy efficiency can be optimised if the electronic instant water heater is used within a solar system for top-up heating.
7
Easy to install
Well thought-out down to the last detail
The MCX SMARTRONIC® simply connect to standard closed outlet taps without the need for unvented water controls.
CSP 3 CSP 6
133 22 186 ≥70
75
Shutoff valve approx.550
Shutoff valve outlet G 3/8“, T-piece Fastening centre distance approx. 520
Cable inlet approx. 553
135
Electrical connection with mains lead (shorten if necessary)
MCX 3/4: MCX 6/7:
Top edge of basin approx. 850
Insert jet regulator:
The appliance does not need to be opened for the installation as it is supplied with a prefitted power cable and a bracket for easy fitting. In the case of a replacement, the wall bracket fits onto the existing holes of most old appliances which are to be replaced. A connection set (T-piece and flexible pressure hose) for the pressure-resistant installation is included in the package of all models with 3/8“ water connectors to make the installation even easier. In each and every case, the mini instant water heater is a space-saving solution. The neat and compact design means the appliance fits under any handwash basin.
9
Replaceable heating cartridge for sustainable service life
Circumferential jointless labyrinth to avoid water inlet (IP 25)
Safety thermal cut-out for maximum operational safety
Ceramic temperature sensor with adaptive control logic
Electronic controls with ECO-ADAPT adaptability
Stainless steel heating element on patented rack for water turbulence
Flow sensor with accurate measuring turbine and run-dry protection
Brass water connections with top-quality nickel plating, with filter strainer
Technical data Model Product code
MCX 4 SMARTRONIC®
MCX 6 SMARTRONIC®
MCX 6-220 SMARTRONIC®
MCX 7 SMARTRONIC®
15003
15004
15006
15005
15007
litres
0.2
0.2
0.2
0.2
0.2
handwash basin / kitchen sink
•/–
•/–
•/•
•/•
•/•
•
•
•
•
•
Nominal capacity Application
MCX 3 SMARTRONIC®
Installation type
undersink unit
Type
closed outlet
Maximum static pressure
1)
MPa (bar)
•
•
•
•
1 (10)
1 (10)
1 (10)
1 (10)
G 3/8“ 2)
Water system connections (thread connection) °C
User set temperature
• 1 (10)
35 – 38 – 45
G 3/8“ 2) 3)
35 – 38 – 45
G 3/8“ 2) 3)
35 – 38 – 45
G 3/8“ 2)
G ½“ 3)
35 – 38 – 45
3)
35 – 38 – 45 3)
Hot water flow rate at ∆t = 25 K 4)l/min
2.0
2.5
3.3
3.4
3.7
Switch-on – maximum flow rate l/min
1.2 – 2.0
1.5 – 2.5
1.5 – 3.3
1.5 – 4.5
1.5 – 3.7
Nominal power rating 6)kW
3.5
4.4
5.7
6.0
6.5
1 / N / PE ~ 220
2 / PE ~ 400 2 × 16
5)
Supply voltage
V
Nominal current
A
Required cable size mm
IES bare wire heating system
19
25
27
4.0
4.0
1.5
2.5 • / IP 25
• / IP 25
• / IP 25
• / IP 25
electronical
•
•
•
•
•
/ Ω cm
• / 1100
• / 800
• / 800
• / 800
• / 1100
•/–
–/•
–/•
–/•
–/•
•
•
•
•
•
2
VDE approved, CE endorsed / Protection class
®
15
• / IP 25
6)
Control
1 / N / PE ~ 220 – 240
8)
Power cable with plug / For permanent connection Solar-compatible (Inlet temperature < 70 °C)
7)
7)
1.5
Dimensions (Height × Width × Depth)
cm
13.5 × 18.6 × 8.7
13.5 × 18.6 × 8.7
13.5 × 18.6 × 8.7
13.5 × 18.6 × 8.7
13.5 × 18.6 × 8.7
Approx. weight (filled with water)
kg
1.5
1.5
1.5
1.5
1.5
• = included resp. yes 1) Also suitable for unpressurised installation 2) ½“ water connections upon request 3) Maximum outlet depends on the rated power, inlet temperature and flow rate, if necessary reduce the flow rate at the tap. Restricted function for reduced power of MCX 3. 4) Temperature increase e.g. from 15 °C to 40 °C 5) Flow limited in order to obtain optimal temperature increase, can be adjusted inside the unit. 6) Regulations vary according to the regional power supply authority. Must be connected by a qualified electrician only. 7) Use the power supply cable supplied. 8) Permissible minimum electrical resistance of the water at 15 °C
Removable rating plate cover The mandatory rating plate is hidden behind a removable cover. This improves the look whilst at the same time ensuring that all important information is right there for the tradesman. The hood’s central safety screw and a screw to adjust the flow rate are under this cover.
11
CLAGE – leading technology for individual water heating on demand CLAGE is an innovative manufacturer for energy-saving hot water technology.
safety are assured. Numerous approvals and awards attest the superior quality and attractive design of CLAGE products.
CFX-U FUNKTRONIC MPS ® under-sink instant water heater for kitchen sink
The new CLAGE app:
Hot Water
DSX SERVOTRONIC MPS ® electronic instant water heater for bathroom
Potable water system ZIP HydroTap® in the tea kitchen
CLAGE GmbH, Pirolweg 1 – 5, 21337 Lüneburg, Germany Fon +49 (0) 4131 89 01-0 · Fax +49 (0) 4131 244 47 E-mail
[email protected], Internet www.clage.com
Subject to technical changes and design changes . Errors and omissions excepted. All pictures © CLAGE 9100-94761 GP-Ba 04.12 3
At the modern factory in Germany the highest standards of quality and product
