Provides Instant Gps Service Indoors.

Transcript

Provides instant GPS service indoors. ROGER GPS repeater provides instant GPS service indoors. It extends the use of any GPS device inside buildings and locations that otherwise would be blocked from GPS signals. Get indoor GPS coverage. 1. ROGER GPS Repeater Package ROGER™ GPS repeater operates by receiving GPS satellite signals with an antenna located outside the building and re-radiating the signal to the indoors. With one ROGER Package You can get indoor coverage radius approximately 10-15 meters. WHAT’S IN THE BOX Outdoor antenna for receiving the GPS signals GPS Repeater Power supply RF-cabling, 19,5m Manual Easy to install! Extend Your indoor GPS coverage with ROGER accessories. 2. ROGER™ GPS Signal Splitter 3. ROGER™ GPS Additional Repeater 4. ROGER™ GPS Line Amplifier READ MORE ABOUT SOLUTIONS: www.gps-repeating.com Technical Specifications ROGER™ GPS repeater is a device that is used to relay GPS signals to places where they cannot normally be. The GPS repeater operates by receiving GPS satellite signals with an antenna located outside the building and reradiating them to the covered space. The GPS receiver can then ‘see’ the satellites indoors. The use of re-radiated signals mean that the GPS receiver is tracking the current GPS status. This means that when the receiver is moved from the indoors to outside, the GPS receiver is instantly tracking the location, instead of time consuming acquisition of current GPS state. Please note that the GPS repeater cannot be used for navigating indoors, as the receiver will always indicate the location of the outdoor antenna instead of a real position. ROGER™ GPS Repeater Size Weight Overall Gain Noise Figure Variable attenuation Impedance Input connector 110*143*28mm 165 g > 40dB < 2dB 0-40dB 50Ω SMA-female Operating temperature Power supply Indoor coverage radius Antenna power output TX antenna gain -25 - +40°C 12 VDC, 300mA Power supply included 10-15 m +5VDC, 100mA max +4dBd, RHCP polarization Other features Automatic gain control Feedback oscillation suppression Manual gain control CE-certified Operating license note Output power limit –60dBm Note: GPS repeaters may require a license or they may not be used in your country. Check licensing conditions with the local (radio) authorities before operating the GPS repeater product. In some countries the ROGER™ package contains instructions and the necessary forms to obtain an operating license from the local authorities. Status/power LED Internal transmit antenna Yes ROGER™ GPS Signal Splitter Size Weight Operating temperature Connectors Frequency range: Impedance: Power 110*143*28mm 185 g -25 - +85°C TNC female input, 5*TNC female output. 1200-1700MHz 50Ω Not required -4dB with DC pass, 4*-12dB ROGER™ GPS Line Amplifier Size Weight Operating temperature Connectors Frequency range Noise figure Impedance: Power supply Gain 110*143*28mm 135 g -25 - +85°C TNC female input TNC female output 1575.42 +/-15MHz filtered <5dB 50Ω +5-12VDC max 20mA through coax (center positive) +15dB Distributed by: Gammeltorv 8, 6 1457 København K Tel: +45 3373 4000 Fax: +45 3373 4001 READ MORE ABOUT SPECIFICATIONS: www.gps-repeating.com