Public Address Paw Ceiling Series

Transcript

Ultra Series SM – 1062 Description: Features Ultra Series features the slimmest loudspeaker Loudspeaker type Coaxial anywhere. Combining cutting-edge technology Cone type Mica cone with TPU surround and our great determination, this new Ultra Mounting Depth 25 mm Series has completely revolutionised the Colour White / Black engineering of loudspeaker. With a mounting Loudspeaker Waterproof depth less than one inch, Greness’ ultra-slim Qualification IP 65 ASTM D4329 & ASTM D2244 (600hrsUV mounting depth that can ever be found loudspeaker can be easily installed into any stabilised) desired surface or panel. ASTM B117 (400hrs saltwater spray) RoHS conform (2002/95/EC) IEC-268-5 (100 hours tested) Even with such a slim design, the high acoustic performance has been preserved to bring tremendous satisfaction to the audience. For those clients that desire for higher level of audio satisfaction, full range SM-1050, SM-1060 and two-way designed SM – 1052, SM – 1062 will provide ideal models. This inspirational artwork is crafted to be completely waterproof with an IP 65 rating. High moisture content and rusting rate of the surrounding environment will not deter the outstanding capability. Long-lasting, U.V. stabilised feature (ASTM D4329 & ASTM D2244) makes the units ideal for outdoor purposes. At home U.V. resistance can provide protection against light radiation. Any type of corrosion is also kept to a minimum level to prolong the life-span of the loudspeaker (ASTM B117). Specification Model SM – 1062 Loudspeaker type 6” Coaxial Rated input power RMS 20W、Max 40W Average Sensitivity 1W / 1m Maximum SPL 1W / 1m 88 ± 2 dB 101dB ± 2 dB/20W Frequency response 90 Hz ~ 20 kHz Operating temperature -20℃ ~ 100℃ Impedance 4Ω Exterior diameter 181 mm Installation diameter 138 mm Mounting depth 25 mm Weight 310 g SM – 1062 Dimensional diagrams Characteristic diagram : INSTALLATION 1. Select a mounting location which will allow the speaker to lay flat and has adequate space. 2. Use the supplited template to mark the mounting holes. See Figure1. 3. Drill a starter hole in the center of the mounting hole. Using a hacksaw blade or a similar tool, cut the mount hole. 4. Drill the four18" mounting holes. 5 .Connect the speaker wire to the speaker terminals and route to stereo. Be sure stripe wire is connected to the positive(+) terminal of speaker. See Figure2. 6. Slide the four U-Clips over the mounting holes and press to hold in place. See Figure3. 7. Place a bead of RTV sealant (or equivalent) around the back rim of speaker basket. 8. Secure the unit with provided screws for intergrated speakers. Or for flush-mount speakers, tighten the screws to secure the unit first before fitting the cover grille onto the speaker. See Figure 3-1. FIGURE3 FIGURE2 + - FIGURE1 FIGURE3-1