Transcript
pulse monitor stand P-MK-01 The pulse monitor stand is an excellent addition to a variety of backwall displays and exhibits. Use this sturdy, stand alone kiosk in a variety of situations to display your multimedia messages.
features and benefits: - State-of-the-art snap button aluminum structure - Frame constructed of 30mm and 50mm lightweight aluminum tubes
-
Choose from four laminate base colors Brushed silver finish on exposed tube Easy step-by-step instructions Lifetime warranty on hardware against manufacturer defects
dimensions: Hardware Assembled unit: 30”w x 78.38”h x 23.6”d 762mm(w) x 1990mm(h) x 600mm(d)
Shipping Shipping dimensions - ships in 1 case: WMC-12x6 case: 52”l x 30”w x 15”h 1320.8mm(l) x 762mm(w) x 381mm(h) Approximate shipping weight (entire kit): 70 lbs / 31.75 kgs
additional information: Monitor mount holds max weight 50 lbs / 22.7 kgs Monitor mount holds max size 40” / 1016mm
Base color options:
silver
black
mahogany
pulse © 2014 Nimlok Display and Exhibit Solutions Worldwide For questions contact your local Nimlok distributor
natural
Parts included Part Label
Qty
Upper frame
x1
Lower frame
x1
Joiner
x4
Base plates
x2
Base x1 Monitor bracket x1
1.
Step 1.
Connect the plates to the base using four screws per plate as shown in the attachement detail below. Assure holes on tubing are facing inward.
BASE TO PLATE T
Thumbscrews
Take four thumbscrews and attach the plate .
2.
Step 2.
Attach the lower frame to the base plates at points 1A and 2A following the labels. Use the joiner to connect as shown in the attachment detail below. Attach the upper frame to the lower frame at points 3A and 4A following the labels. Use the joiner to connect as shown in the attachment detail below.
3A
3A 3A
4A
4A 4A
1A 1A
2A 2A 1A
50mm TUBING
STEP 1 SLIDE THE JOINER INTO THE TUBING SO THE THE HEX SCREW SITS IN THE HOLE ON THE orientation of holes TUBING STEP 2 TIGHTEN THE HEX SCREW SO THE JOINER SEPERATES AND TIGHTENS AGAINST THE INSIDE OF THE TUBING, LOCKING THE JOINER AND TUBING TOGETHER
2A
HEX SCREW TUBING JOINER HEX SCREW
1
50mm TUBING 1
3.
Step 3.
To attach the monitor mount, put square head bolts through the back of the pre-drilled tube. Slide monitor mount onto bolts and secure with wingnuts. Position mount where desired.
MEDIUM MONITOR TO 30MM TUBE TUBE
SQUARE HEAD BOLTS THROUGH TUBE
M-M MB
TUBE
M-M MB
4.
check out these related products:
pulse kit 01
pulse kit 02
pulse kit 03
pulse kit 04
pulse kit 05
pulse kit 06
We continue to improve and modify our product range and reserve the right to vary the specifications without prior notice. All dimensions and weights quoted are approximate and we accept no responsibility for variance. E&OE. See Graphic Templates for graphic bleed specifications.
