Preview only show first 10 pages with watermark. For full document please download

Pz1500.1 / Pz2500.1 Mono Amplifier Application

   EMBED

Share

Transcript

h a n g e Vi e O W ! XC N y bu to k lic These sub bass amplifiers can be used in any of the bi-amplification systems described in this manual, replacing the 2 channel amplifiers as per the illustrations. .d o Crossover frequency control checklist: LOW PASS: 40Hz to 150Hz SUBSONIC:15 Hz to 55 Hz BASS EQ: 0 to +12dB Interconnect cable checklist: Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. Connect the LINE OUT to the inputs of the system highs amplifier. Level control checklist: Refer to the section “Setting up systems after installation for best performance” Use at least #12 gauge speaker wiring. The amps have dual speaker terminals, simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers which have multiple positive and negative connections for ease of wiring. The 2 positives are the same internally and the 2 negatives are the same internally. Minimum final loudspeaker impedance: 1-Ohm. MONO SUBWOOFER REMOTE CONTROL SPEAKER OUTPUT + + - POWER PROTECT MI N MAXX FUSE LOW PASS FULL RANGE STEREO LINE INPUT REM BATT+12V L PARALLEL MONO SUBWOOFERS 2-OHMS EACH MINIMUM TO BATTERY +12v VIA FUSE REMOTE TURN-ON CHASSIS GROUND GND R OUTPUT INPUT R L POWER INPUT LEVEL 0dB 12dB 15Hz 55Hz 40Hz 150Hz 6V 0.2V BASS SUB BOOST SONIC DESIGNATED MONO OUTPUT FROM HEAD UNIT POWER INPUT FUSE GND REM BATT+12V SPEAKER OUTPUT + + - Y-ADAPTOR NOT USED Note: You can use the Radio/CD designated mono line output or a full range stereo line output. For full range stereo line output, you will need an optional “Y-Adaptor” as shown. 6 m w .c o m c u -tr a c k C Basic application o .d o w w w w w C lic k to bu y N PZ1500.1 / PZ2500.1 MONO AMPLIFIER APPLICATION w er O W F- w PD h a n g e Vi e ! XC er PD F- c u -tr a c k .c