Q47x/xi Assembly Instructions (2014)

Transcript

Assembly Instructions Base Box Base Mast Boot Base Hardware Moving Handlebars (L and R) B-1 (4) Q47x Console Box B-2 B-3 (4) (2) Console Assembly Console Back Q47xi Console Box Console Assembly Console Back Mi Mi Boost your Workout B-6 Console Mast Right Pedal Lever Access Panel B-4 (2) Top Cover Information Packet Power Supply #2 Phillips B-5 (2) Handlebar Covers (2) #2 Phillips Information Packet Power Supply 17mm Console Hardware C-1 (4) C-2 (5) B-7 #2 Phillips Powerband Handle (2) Powerband (2) Console Hardware Wireless Heart Rate C-1 (4) C-2 (5) Transmitter and Strap #2 Phillips #2 Phillips #2 Phillips B A C Moving Handlebars & Adjustment Pedal Lever Mast & Console Assembly        Attach handlebar at hub with B-1 (Qty 2), B-2 (Qty 2), B-3 (Qty 1). Tighten to (30 ft-lb).  Connect heart rate and control button cables.  Repeat for second handlebar.      Remove bolt from 3-pivot link. Attach pedal lever; tighten to 33 ft-lb.  Slide mast over screws on base; tighten.  Connect cable connector (mast to base, Qty 1); secure cables to frame with B-6.  Route heart rate cable through rear hole in mast and connect to base cable. Optional: Adjust moving handlebars for 2” longer / shorter reach:  Hold handlebar; remove nut and reposition link. (Hole  Connect console cables (2) and ground cable. Position  console assembly over top of mast; attach with C-1 (Qty. 4). Connect power supply to unit and to power outlet. Verify that console LEDs light and stride motors move. closest to user provides shortest rech.)  Replace nut; tighten (17 ft-lb).  Align console back with console assembly. Snap Repeat for second handlebar. Handlebars must be set to console back and console assembly together at top. same position for proper functioning. Call Customer Service for assistance as needed. Secure console back with C-2 (Qty 5).  D Access Panel & Handlebar Covers E F Top Cover & Mast Boot Level & User Set-up                    Loosen screws on sides of lower shroud. Fit metal plate behind back shroud and side tabs into slots over side screws. Secure back with B-4 (Qty 2); tighten side screws. Place handelbar covers. USA & Canada 888-OCTANE4 107949-001 REV A ©2013 Octane Fitness. All rights reserved.    Position top cover; hold back edge in place; shift front edge forward and down. Press bottom edge to snap cover into place; secure with B-5 (Qty 2). Wrap mast boot around mast; tuck into access panel. Questions? octanefitness.com       Adjust and lock levelers; make sure nut is tight. Connect power supply to unit and to power outlet. Complete User Set-up (press and hold Level (/) — See Operations Manual for instructions. Before 1st use and as needed, clean tracks with a cloth and a solution of mild soap and water. Latin America/Asian Pacific 001-763-757-2662 Europe/Middle East/Africa 31-10-2662412