Transcript
QUBOne Bluetooth Speaker TM
CONTENTS Page 3 4 5 6 7-8 9 10 11
Important Safety Instructions Controls Power Switch Charging Bluetooth Connection Auxiliary Input Receiving and Making Calls Specifications
IMPORTANT SAFETY INSTRUCTIONS •
Read, follow and keep these instructions.
•
Do not use this product near water or wet surfaces.
•
Clean only with a dry cloth.
•
Do not expose to extreme high or low temperatures.
•
Only use the supplied cables for charging and playback.
3
CONTROLS Power Switch
Pairing LED
Rotate and hold: volume up\down Rotate and release: track +\Push and release: play \ pause
4
CHARGING The first time you use your Bluetooth speaker, please charge it for at least 1.5 hours. During the first charge, do not turn on the device.
Using the supplied USB cable connect to a USB power source (eg. a computer). While charging, the yellow LED on the rear of the unit will illuminate. When fully charged, the yellow LED will turn off. After the first charge, you can play and charge at the same time.
5
BLUETOOTH CONNECTION When the speaker is turned on, you should hear a voice prompt and the blue pairing LED on the side of the device will flash quickly indicating that pairing mode is activated and it is searching for a Bluetooth source. The blue LED will flash slowly when it is attempting to connect to the device it was paired to last. Go to the Bluetooth menu of your source device and connect to QUBOne from the list of devices. If asked for a code, enter 0000. Once the connection is achieved, the pairing LED will stop flashing and the speaker will emit two short beeps. You are now connected and can play from your source.
6
TROUBLE CONNECTING? Make sure that no other source in range is connected. Only one connection can be made at a time, The speaker may automatically connect to a source it has been paired with in the past. Turn off the speaker, then on again. Try pairing again. Make sure the source is Bluetooth compatible and that the Bluetooth is activated. Review your source device documentation for Bluetooth pairing instructions.
7
AUXILIARY INPUT CONNECTION Insert the supplied 3.5mm cable into the speaker’s AUX input. The pairing LED will illuminate when this connection is made. Connect the other end to the output of your source device. You can now play your content.
8
The Bluetooth will be disabled anytime a 3.5mm cable is inserted into the AUX input.
RECEIVING AND MAKING CALLS Your speaker will allow you to make hands free calls provided your phone is connected via Bluetooth. The AUX connection cannot be used for this function. To make a call: Use the phone as normal, select the Bluetooth speaker when prompted. To receive a call: Either push the PLAY/PAUSE button on the side of the speaker or answer the call with the phone making sure to select the Bluetooth speaker when prompted. Ending a call: Either push the PLAY/PAUSE button on the side of the speaker or hang up using the phone as you normally would.
9
SPECIFICATIONS Active Drivers: 1 x 40mm (1.57 Inches) Passive Drivers: Amplifier Power: 3.2 Watts Frequency Response: 85Hz - 17KHz Battery Type: Lithium-ion Polymer Battery Capacity: 850mAh
10
Play Time: 3 to 5 Hours Recharge Time: 1.5 Hours Bluetooth Profiles: HFP-A2DP/ARVCP Bluetooth Range: 10 meters in open space Dimensions: 60 x 60 x 59 (mm) Weight: 280 grams
WARRANTY Maxxsonics USA Inc. warrants this product, to the original consumer purchaser, to be free from defects in material and workmanship for a period of one (1) year from the date of purchase. Maxxsonics USA Inc. will, at it’s discretion, repair or replace defective products during the warranty period. Components that prove to be defective in materials or workmanship must be returned to the original authorized Maxxsonics USA Inc. retailer from where it was purchased. A photocopy of the original receipt must accompany the product being returned. This warranty is limited to defective parts and specifically excludes any incidental or consequential damages connected therewith. To view the full warranty, please visit the website. The Bluetooth™ word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MB Quart is under license.
11
