Transcript
Quick Installation Guide
1000Base-SX/LX Fiber Converters
Table of Contents Table of Contents Français ..................................................................................................... 1 1. Avant de commencer ......................................................................... 1 2. Installation du matériel ...................................................................... 2
Spefications .............................................................................................. 4 Ordering Information................................................................................... 5 Troubleshooting ........................................................................................ 6
Version 02.02.2009
1. Avant de commencer Contenu de l'emballage Convertisseur fibre Guide d’installation rapide Alimentation AC (7,5 DC, 1,5A)
Configuration minimale Un environnement exempt de toute source de génération de champ électromagnétique fort (comme les moteurs), de vibration, de poussières et veillez à ce qu’il ne soit pas directement exposé aux rayons du soleil. Châssis TFC-1600 (non fourni) ou une surface plane pouvant supporter le poids de du convertisseur fibre Switch Gigabit 10/100/1000Mbps Câbles fibres multi-mode ou monomode Câble Ethernet RJ-45 CAT-5 our CAT-6
Détails du produit Model Name
Multi/Single-Mode
TFC-1000MSC TFC-1000S20
Multi-Mode
TFC-1000S50
Single-Mode
Fiber Connector SC (Duplex)
TFC-1000S70 TFC-1000S10D3 Single-Mode Bidirectional TFC-1000S10D5
1 Français
SC (Simplex)
2. Installation du matériel Installation de 2 convertisseurs fibre autonomes 1. Branchez le câble fibre aux convertisseurs fibre. Ce câble doit être multi-mode pour le TFC-1000MSC et monomode pour le TFC-1000S20/S50/S70/S10D3/ S10D5.
2. Branchez un câble Ethernet RJ-45 ente le port Ethernet des convertisseurs de fibre et le port Ethernet de votre switch (e.g TEG-S160TX ou TEG-S240TX). 3. Branchez l'adaptateur secteur à l'arrière du convertisseur fibre.
Remarque: Les câbles TX et RX doivent être inversés par rapport à la connexion fibre opposée. Remarque: Le TFC-1000S10D3 doit être appareillé avec le TFC-1000S10D5.
2 Français
Installation d’un convertisseur media dans un châssis 4. Dévissez le cache baie de la baie choisie sur le châssis.
5. Desserrez la vis à molette et enlevez le convertisseur fibre du logement métallique
6. Glissez le convertisseur media dans un logement disponible et serrez la vis à molette.
L'installation est maintenant complète. Enregistrez votre produit Afin d’être sûr de recevoir le meilleur niveau de service clientèle et le meilleur support possibles, veuillez prendre le temps d’enregistrer votre produit en ligne sur:
www.trendnet.com/register Nous vous remercions d’avoir choisi Trendnet
3 Français
Specifications Applicable Standards:
IEEE802.3ab 1000BASE-TX IEEE802.3z 1000BASE-SX/LX
Fixed Ports: Forwarding rate:
1 TX port, 1 FX port 1488000pps for 1000Mbps
LED Indicators:
PWR, LNK/ACT
DIP Switches:
Switch 1: On(Forced Mode); Off(Auto-Negotiation) Switch 2: On(LLR enabled); Off(LLR disabled) 1000BASE-T Cat. 5e or Cat. 6 EIA/TIA-568 100-ohm screened twisted-pair (STP)
Cable :
1000BASE-SX 62.5/125µm multi-mode fiber optic cable 50/125µm multi-mode fiber optic cable 1000BASE-LX 9/125µm single-mode fiber optic cable 10/125 µm single-mode fiber optic cable
Dimensions:
L120 × W88 × H25 mm
Weight:
305 g External power adaptor 7.5V 1.5A
Power: Power Consumption:
5.5 Watts Max.
Temperature:
Operating: 0°C ~ 40°C (32°F ~ 104°F) Storage: -25°C ~ 70°C (-13°F ~ 158°F)
Humidity:
10 ~ 90%, non-condensing
Certifications:
FCC part 15 Class B, CISPR ClassB, VCCI Class B, CE Mark
4
Ordering Information Media Converters RJ-45 Port Model Number
Fiber Port
Speed (Mbps)
Cable/Connector
Max. Distance
Speed (Mbps)
Wavelength
TFC-1000MSC
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
1300nm
MMF 62.5/125µm (50µm or 62.5µm ) 550M SC 50/125µm
TFC-1000S20
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
1300nm
SMF (10µm ) SC
20 km
TFC-1000S50
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
1300nm
SMF (10µm ) SC
50 km
TFC-1000S70
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
1300nm
SMF (10µm ) SC
70 km
TFC-1000S10D3
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
TX: 1310nm RX: 1550nm
Bi-directional SMF (10µm ) SC
10 km
TFC-1000S10D5
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
TX: 1550nm RX: 1310nm
Bi-directional SMF (10µm ) SC
10 km
TFC-1000S40D3
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
TX: 1310nm RX: 1550nm
SMF (10µm ) ST
40 km
TFC-1000S40D5
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
TX: 1550nm RX: 1310nm
SMF (10µm ) SC
40 km
TFC-1000S60D3
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
TX: 1310nm RX: 1550nm
Bi-directional SMF (10µm ) SC
60 km
TFC-1000S60D5
1000
Cat. 5E, 6 EIA/TIA-568 100-ohm STP
100M
1000
TX: 1550nm RX: 1310nm
Bi-directional SMF (10µm ) SC
60 km
Max. Cable(/125 µm ) Distance /Connector 220M
Note: MMF (multi-mode fiber); SMF (single-mode fiber)
5
Troubleshooting Q1: After connecting the Fiber converter, the LEDs do not turn on. What should I do? A1: First, check that the power outlet is receiving power. Second, make sure the power adapter is firmly connected to the Fiber converter and the power outlet. Third, make sure the Ethernet and the Fiber cables are connected. Q2: All the LEDs are on, but I can't make a connection. What should I do? A2: First, verify that you are using the proper fiber cable (e.g. multi-mode fiber cable for multi-mode converter; single-mode fiber cables for single-mode converters). Second, verify that the TX and RX cables have been reverse on the opposite Fiber connection. Third, power down the fiber converters and the switches. Wait 15 seconds, then plug the switches and the fiber converters back in. Q3: What is the maximum distance that is supported by the fiber converter? A3: Please reference section 4 for distance information. If you still encounter problems or have any questions regarding the Fiber Converters please contact TRENDnet's Technical Support Department.
6
Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. Fiber Converters
5 Year Limited Warranty
If a product does not operate as warranted above during the applicable warranty period, TRENDnet shall, at its option and expense, repair the defective product or deliver to customer an equivalent product to replace the defective item. All products that are replaced will become the property of TRENDnet. Replacement products may be new or reconditioned. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product through any unauthorized service center. This warranty is voided if (i) the product has been modified or repaired by any unauthorized service center, (ii) the product was subject to accident, abuse, or improper use (iii) the product was subject to conditions more severe than those specified in the manual. Warranty service may be obtained by contacting TRENDnet office within the applicable warranty period for a Return Material Authorization (RMA) number, accompanied by a copy of the dated proof of the purchase. Products returned to TRENDnet must be preauthorized by TRENDnet with RMA number marked on the outside of the package, and sent prepaid, insured and packaged appropriately for safe shipment.
7
WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER’S SOLE REMEDY SHALL BE, AT TRENDNET’S OPTION, REPAIR OR REPLACEMENT. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. TRENDNET NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE OR USE OF TRENDNET’S PRODUCTS. TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER’S OR ANY THIRD PERSON’S MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR OR MODIFY, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD. LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT TRENDNET’S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE. Governing Law: This Limited Warranty shall be governed by the laws of the state of California. Note: AC/DC Power Adapter, Cooling Fan, Cables and Power Supply carry 1-Year Warranty
8
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. ADVERTENCIA En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria existente en el pais o zona de instalación.
Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register
20675 Manhattan Place Torrance, CA 90501 USA Copyright ©2009. All Rights Reserved. TRENDnet.
