Transcript
Installation Quick Reference The IP Endpoint Company
Protective Dome Kit 011287
Parts List ●
(1) Protective Dome Kit
Operation Guide ●
You can download the documentation from the following web page: http://www.cyberdata.net/products/voip/accessories/domeenclosure/docs.html
Wall Mounting Screw Kit (Part of the Dome Kit) (4) #8x1.5" Pan Head Phillips Self-Tapping Screw
(4) Plastic Ribbed Anchor
Removing the Auxiliary Strobe Backplate to Install the Dome Kit Mounting Screws (3x)
Backplate
Contacting CyberData Corporate Headquarters CyberData Corporation 3 Justin Court Monterey, CA 93940, USA Phone: 831-373-2601 Fax: 831-373-4193 www.CyberData.net Quick Reference
Sales: (831) 373-2601 ext. 334 Support: 831-373-2601 ext. 333 Web: http://www.cyberdata.net/support/contactsupportvoip.php RMA Dept: (831) 373-2601 ext. 136 Email:
[email protected] RMA Status: http://www.cyberdata.net/support/rmastatus.html Warranty information is available at: Web: http://www.cyberdata.net/support/warranty/index.html 930825A
© 2013, CyberData Corporation, ALL RIGHTS RESERVED
Installing the Dome Kit 1. Remove the backplate from the VoIP Strobe by removing the three Mounting Screws. See the section called, "Removing the Auxiliary Strobe Backplate to Install the Dome Kit" on the front page.
7
#8-32 x 3/4" Socket Head Cap (9/64" Hex) Machine Screw (6x) (Hex Key/Bit Not Included) Part of Dome Kit
7
2. Install the Backplate to the Dome Kit Adapter Plate with the three #8 x 5/16-inch Pan-Head Phillips Machine Screws.
#8 Washer (6x) Part of Dome Kit
7
Note Only three screws are being used. Make sure that the mount is located correctly or interference will occur.
Clear Cover with Gasket Part of Dome Kit
3. Install the Dome Kit Backbox onto the wall with the Wall Mounting Kit. 4. Run the network cable (not provided) through the conduit (not provided), NPT Hub, Adapter Plate, and then through the Backplate into the network connector (J1). Auxiliary Strobe 5. Secure the Backplate with the three Mounting Screws that were removed in Step 1.
Network Connector Here
(J1) Remote Strobe Cable Part of Auxiliary Strobe
6. Secure the Adapter Plate with the Flat-Head Machine Screws. 7. Install the Clear Cover with the Socket Head Cap Screws and Washers.
1&5
Auxiliary Strobe
Mounting Screw (3x)
2
2 Backplate
#8 x 5/16" Pan Head Phillips SEMs Machine Screw Three (3) Provided
Part of Auxiliary Strobe
2
2 Mounting Holes
Rotate Backplate and/or
Dome Kit Adapter Plate for
Desired Conduit Mounting Directions Only three (3) screws are being used. Make sure that the mount is located correctly or interference will occur.
Not Used
Keyed Edge for Alignment
6
#8-32 x 3/8" Flat Head Phillips Machine Screw (4x) Part of Dome Kit
2
3/4" NPT Hub Part of Dome Kit
Dome Kit
Adapter Plate
4
Conduit (Not Shown & Not Provided)
Keyed Edge for Alignment
3
Dome Kit Backbox
© 2013, CyberData Corporation, ALL RIGHTS RESERVED
930825A
Quick Reference
