Transcript
Speaker Hookup
QUICK SETUP
Front high right speaker
Model : DTR-40.1
Front wide right speaker
Front right speaker
Front left speaker
Front wide left speaker
Front high left speaker
Center speaker
Thank you for purchasing this product. This quick setup sheet shows the typical hookup method for connecting speakers and AV components (DVD/BD player, TV, cable/satellite receiver). For more detailed hookup information and operating instructions, please see the Instruction Manual.
Sub woofer
Speaker Layout (Main Room) Front High Left
Front High Right
TV Front Front Wide Left Left
Center
*1 Front Front Right Wide Right
1/2''-5/8'' (12-15mm)
Surround Left
Surround Back Left
Listener
Surround Right
Surround Back Right
Powered subwoofer
Surround right speaker
Surround back Surround back right speaker left speaker
Surround left speaker
See the other side of this sheet for the AV component hookup. *1 The same signal is output from each jack. (C) Copyright 2009 ONKYO CORPORATION Japan. All rights reserved.
SN 29400036
* 2 9 4 0 0 0 3 6 *
AV Component Hookup With an HDMI cable you can send both audio and video with a single cable, making connecting simple and keeping wires neat. If you have an HDMI-compatible TV and players, you can connect them to the AV receiver with HDMI cables. Digital audio signals received at HDMI IN input are output to the speakers and headphones connected to the AV receiver.
See the other side of this sheet for the speaker hookup.
If your TV or player doesn’t support HDMI, use the analog or digital connections shown below.
IF NO HDMI DIGITAL OUT COAXIAL
AUDIO OUT
VIDEO OUT
TV
DVD player
L VIDEO 1 IN
TV
R
HDMI IN
HDMI OUT
Please ensure the monitor input (VIDEO 1, VIDEO 2, VIDEO 3, etc.) selected corresponds to actual connection used.
DVD/BD player
Coaxial feed from TV antenna HDMI OUT
Cable/satellite
Using the HDMI Inputs If there’s no picture on your TV, you’ll need to assign the HDMI inputs as necessary using the onscreen setup menus. If you connect your DVD/BD player to the AV receiver’s HDMI IN 1, and connect your cable/satellite receiver to HDMI IN 3, as shown, it’s not necessary to change the default assignments.
If you are not using cable/satellite box, please refer to the instruction manual.
Antenna input (e.g., RF IN)
Menu
On the front panel
DIGITAL OUT
VIDEO OUT
AUDIO OUT
Cable/ satellite
Antenna input (e.g..RF IN)
If you are not using cable/satellite box, please refer to the instruction manual.
On the front panel
If there’s no sound, you’ll need to assign the digital inputs as necessary using the setup menus on the AV receiver’s display. If you connect your DVD player to the AV receiver’s DIGITAL IN COAXIAL 1, and connect your cable/satellite receiver to the DIGITAL IN COAXIAL 3, as shown, it’s not necessary to change the default assignments.
1. Input/Output Assign Monitor Out HDMI Input Component Video Input Digital Audio Input
1–2. HDMI Input DVD/BD VCR/DVR CBL/SAT GAME AUX
R
COAXIAL
Using the Digital Inputs
1. Input/Output Assign 2. Speaker Setup 3. Audio Adjust 4. Source Setup 5. Listening Mode Preset 6. Miscellaneous 7. Hardware Setup 8. Remote Controller 9. Lock Setup
1. 2. 3. 4.
Coaxial feed from TV antenna
L
HDMI1 HDMI2 HDMI3 HDMI4 FRONT
The onscreen setup menus appear only on a TV that is connected to the HDMI OUT. If your TV is connected to the composite video or S-Video MONITOR OUT, or the COMPONENT VIDEO MONITOR OUT, use the AV receiver’s display when changing settings.
