Transcript
QUICK START GUIDE
IQ®SET - quick start guide
Launch the Voice Commissioning Applet
Navigate to the point using voice commands
Request data to be read from or written to the system
“
Read value
IQSET will announce the live data through the headset and provide a large screen display on the laptop screen
About the headset
“
The value of sensor 1 is 26.72
“ “
1 2 3 4 5
Connect IQ®SET into the Trend system and a suitable headset into the laptop
The Voice Commissioning Applet is compatible with any Windows® compatible (Bluetooth/DECT) headset/microphone, providing it is correctly installed and set up. The Voice Commissioning Applet has been successfully tested with: Blue tooth Jabra Motion UC DECT; Plantronics Savi 400 Series (USB power receiver); Jabra Pro™ 900 Series (Mains powered receiver). Please note that Trend cannot guarantee compatibility with individual devices.
USEFUL COMMANDS NAVIGATE AROUND THE SYSTEM USING
Select LAN
e.g. “Select LAN 0” Select Controller e.g. “Select Controller 43” Select Module e.g. “Select Sensor 10” Other display modules supported are; Knob, Switch, Digital Input, Driver, Loop & Address module
READ DATA
Read e.g. “Read Value” Other parameters supported are; Label, Units, Offset, Status.
WRITE DATA
Write value to e.g. with a knob “Write value to 21” Other adjustments are supported such as digital states
TO OVERRIDE AN ANALOGUE DRIVER “Set override value to 50” “Set override output to ON”
TO RETURN THE DRIVER TO AUTOMATIC CONTROL “Set override output to OFF”
“VOICE PAUSE” & “VOICE RESUME”
When you need to talk to someone rather than the laptop Repeats the previous command
“WHERE AM I?”
“
“REPEAT”
IQSET will annunciate which controller you are currently monitoring
“DETECT SERVICE BUTTON”
Press the Service button on a controller on the network and IQSET will annunciate its address To end the sensor connection test say “Stop”
“START SENSOR CONNECTION TEST”
IQSET will now listen to your controller & annunciate the sensor number for any sensor you open circuit. To end the sensor connection test say “Stop”
BEMS Commissioning
Just got easier... with voice
Disconnect sensor
Return to laptop and check sensor feedback
“Reducing the time to commission a BEMS system using voice commands”
Return to sensor and reconnect
Trend Control Systems Limited Albery House, Springfield Road, Horsham, West Sussex, RH12 2PQ, UK. Tel:+44 (0)1403 211888 www.trendcontrols.com
