Transcript
Quick Start Guide ESUG4P-PG2-D* Introduction Welcome to KBC Network’s Quick Start Guide for the ESUG4P-PG2, 6 port, PoE switch. This document provides some quick tips on how to get up and running. For more detailed information see the Downloads section below.
Industrial Ethernet Switch System Contents
Equipment Required for Physical Deployment
Qty Description 1
Ethernet switch fitted with DIN rail mount.
2
Wall-mount brackets with screws.
1
Pluggable terminal block.
You will need a 50 - 57Vdc power supply, these are supplied separately.
Features: • • • • • •
IEEE802.3at on 4 ports Dual redundant power input Alarm output for power supply Full & half duplex operation MDI/MDI-X IP30 casing
Downloads Installation manual Other features and functions are described in the unabridged manual: http://www.kbcnetworks.com/esug4p-pg2series/network-products/esug4p-pg2-series Specification sheet: http://www.kbcnetworks.com/esug4p-pg2series/network-products/esug4p-pg2-series
QSG_ESUG4P-PG2-Rev1112 Copyright © KBC Networks Ltd. 2011
www.kbcnetworks.com
Quick Start Guide ESUG4P-PG2-D* Configuring the ESUG4P-PG2-D* 1. 2. 3.
Connect the DIN rail or wall-mount brackets as required. Connect a 50 - 57Vdc power supply, (supplied separately). If using only one power source, connect pin 1 to pin 5 and pin 2 to pin 6 otherwise the Power Fail LED will be lit.
Industrial Ethernet Switch ESUG4P-PG2-D* LED Status Indicators LED
Status
PWR1
ON
Power is supplied to the unit
Need Help/Troubleshooting?
OFF
No power to the unit
ON
Power is supplied to the unit
Visit our website http://www.kbcnetworks.com or contact your nearest KBC office or dealer:
OFF
No power to the unit
ON
Power to PWR1 or PWR2 has failed
OFF
Power is functioning to both or none of the power inputs.
ON
The port is supplying power to the powered device.
OFF
There is no powered device attached or the power
ON
SFP port link established
PWR2 P-Fail
PoE 1-4
P5 & P6
4. 5. 6.
Install SFP modules as required. Link external devices to the switch with appropriate cables. Connect the fault alarm contact if required.
Description
FLASH
Active data flow
OFF
No connection to the network
APAC: Phone: +65 98463323 Email:
[email protected] EMEA: Phone: +44(0)1622 618787 Email:
[email protected] USA: Phone: +1 949-297-4930
Toll Free: +1 888-366-4276 Email:
[email protected]
Ethernet RJ45 Port P1 – P4 Status LED Each RJ45 Ethernet port has two indicators. The lower green lamp indicates port speed, and the upper green lamp indicates port link state. Lower
ON
Full duplex link
FLASH Collisions are occurring
Upper
OFF
Half duplex link or no connection
ON
Effective network connection has been established for the port
FLASH Data traffic is passing through the port OFF
QSG_ESUG4P-PG2-Rev1112 Copyright © KBC Networks Ltd. 2011
No effective network connection has been established for the port
www.kbcnetworks.com
