Transcript
Installation Instructions
SD-DO
Display | Quickshift Donut
! The Spacedec Display Quickshift Donut is to be used on 42mm and 50mm diameter poles only. ! The Manufacturer accepts no responsibility for incorrect installation. Component Checklist Check you have received all parts against this Component Checklist prior to installation. Quickshift Donut (x1)
42mm Front Donut Insert (x1)
42mm Rear Donut Insert (x1)
Hardware Security Screw (x1) (optional)
Visidec Groove Lock (x1)
NOTE: Phillips-head screwdriver not supplied
Mounting Screws M4x10mm Screw (x4)
3mm Allen Key (x1)
M4x12mm Screw (x4)
5mm Allen Key (x1)
M4x16mm Screw (x4)
Step 1. Install Quickshift Donut Select your correct product configuration: A, B, or C. A. Use this configuration with a standard 50mm pole (No inserts required)
B. Use this configuration with a Visidec 42mm extrusion pole Front Donut Insert
C. Use this configuration with a standard 42mm pole
Rear Donut Insert
Front Donut Insert
Rear Donut Insert
Groove Insert
OR
OR Note: Ensure inserts are fitted in correct orientation.
Arrows point to top surface Slide the Quickshift Donut onto the pole (with the lever open), removing the End Cap if necessary. Rear groove insert must align with slot in the Pole.
Slide the Quickshift Donut into the desired position. If necessary, adjust the tension between the Quickshift Donut and the Pole using the 5mm Allen Key supplied.
Groove Insert
TIGHTEN
LOOSEN Slot
Once in place, close the lever to lock the Quickshift Donut in the desired position.
(Visidec 42mm pole shown)
WARNING: Be careful not to overtighten
CLOSE
Step 2. Remove VESA plate from Quickshift Donut Press and hold the Release Buttons (one on either side).
Whilst holding the Release Buttons, remove the VESA Plate. VESA Plate
LIFT Release Button Release Buttons Step 3. Attach the VESA plate to your Display There are two mounting hole configurations: • 75 x 75mm • 100 x 100mm Choose appropriate Mounting Screws from the Hardware supplied to suit your Display.
Mounting Screws (x4) VESA Plate
Top of Display 75mm (3”) 100mm (4”)
75mm (3”)
100mm (4”)
Back of Display Step 4. Attach your Display to the Quickshift Donut Hook the top of the VESA plate onto the Quickshift Mount. VESA plate
Press and hold the Release Buttons. Gently insert bottom of VESA Plate into Quickshift Mount. Release Buttons to lock in place.
(optional) Insert the Security Screw, and tighten using a Phillips-head Screwdriver.
TIGHTEN Release Button Back of Display
Phillips-head Screwdriver
Step 5. Adjusting the VESA Ball Mount Position your Display to the desired viewing angle, using the 40° angular movement allowed by the VESA Ball Mount. Loosen (-Kg)
Depending on the weight of the display, it may be necessary to make adjustments to the VESA Ball Mount. If the display does not hold its position, or is too resistant, adjust the Tension Plate located at the rear of the VESA Ball Mount (see diagram right). To make any adjustments tension evenly using the 3mm Allen Key supplied. Apply half a turn at a time to each screw on the Tension Plate to adjust evenly.
Tension Plate
3mm Allen Key
Tighten (+Kg)
Check the display, and then adjust again if necessary. Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 26.09.11 ©
