Preview only show first 10 pages with watermark. For full document please download

Rack Mounting Kit For 19-inch Racks Rm Kit For Installation Of One 19

   EMBED

Share

Transcript

Rack Mounting Kit for 19-inch Racks RM-36 RM Kit for Installation of One 19-inch Unit KIT CONTENTS • Two short brackets • Six flat-headed screws • Four 5 mm Philips screws EQUIPMENT NEEDED • A 3 mm Philips screwdriver INSTALLATION Warning Disconnect all cables including the power cord from the unit before performing the installation procedures. To install one unit in the ETSI-type 19-inch racks: 1. Fasten the RM-36 kit brackets to the side panels of the unit (see Figure 1). 2. Place the unit in the rack and fasten the brackets to the side rails of the rack using two screws on each side (not included in the kit). Figure 1. Installing a Unit in the ETSI-Type 19-inch Racks Rack Mounting Kit for 19-inch Racks RM-36 RM Kit for Installation of One 19-inch Unit To install one unit in the ANSI-type 19-inch racks: 1. Fasten the RM-36 kit brackets to the side panels of the unit (see Figure 2). 2. Place the unit in the rack and fasten the brackets to the side rails of the rack using two screws on each side (not included in the kit). Figure 2. Installing a Unit in the ANSI-Type 19-inch Racks www.rad.com International Headquarters 24 Raoul Wallenberg Street Tel Aviv 69719, Israel Tel: 972-3-6458181 Fax: 972-3-6498250 Email: [email protected] North America Headquarters 900 Corporate Drive Mahwah, NJ 07430, USA Tel: (201) 529-1100 Toll free: 1-800 444-7234 Fax: (201) 529-5777 Email: [email protected] 190-228-12/05  2005 RAD Data Communications Ltd. Specifications are subject to change without prior notice.