Preview only show first 10 pages with watermark. For full document please download

Rack Mounting Kit For 19-inch Racks Rm Kit For Installation Of One Or

   EMBED

Share

Transcript

Rack Mounting Kit for 19-inch Racks RM-5 RM Kit for Installation of One or Two Units KIT CONTENTS • One long rack adapter • Eight round-headed screws • Four flat-headed screws • Four brackets EQUIPMENT NEEDED • A 3 mm (0.12-inch) Phillips screwdriver • Four 5 mm (0.2-inch) Phillips screws. INSTALLATION Warning ➤ Disconnect all cables including the power cord from the unit before performing the installation procedures. To install one unit (see Figure 1): 1. Insert the unit through the hole of the long rack adapter. 2. Attach a bracket to each side wall of the unit using the round-headed screws. 3. Attach the brackets to the long rack adapter using the flat-headed screws. 4. Place the unit in the rack and fasten the long rack adapter to the side rails of the rack using two 5 mm (0.2-inch) screws on each side (not included in the kit). Long rack adapter Bracket Flat Headed Screws (2 Places) Figure 1. Installation of a Single Unit Round Headed Screws (4 Places) Rack Mounting Kit for 19-inch Racks RM-5 RM Kit for Installation of One or Two Units ➤ To install two units: Repeat the steps explained in the single unit installation (see Figure 2). Figure 2. Installation of Two Units 190-202-11/00  2000 RAD Data Communications Ltd. Specifications are subject to change without prior notice.