Transcript
Lutron Specification Submittal Multi-Location Dimmer with Neutral for Incandescent and Magnetic Low-Voltage Lighting Loads, Interface Modules and Power Boosters RAN-600LM, RA-AD Model No.: c RAN-600LM- c RA-ADGloss Colors: c WHite c IVory c ALmond c Light Almond c GRay c BRown c BLack Satin Colors: c HoT c KiWi c OChre c LiLac c TerraCotta c Desert Stone c STone c LimeStone c Blue MisT c Sea Glass c MidNight c TauPe c EggShell c BIscuit c SnoW C
Dimensions in B
E
A Dimmer
D Accessory Dimmer
A B C D E
mm
2.93 74 4.69 119 .30 8 1.37 35 2.75 70
Note: Dimmers shown with Lutron Designer Wallplate
4 Specifications POWER MOUNTING TEMPERATURE DESIGN
4 Features
Input : 120/127VAC, 50/60Hz (requires a neutral wire connection) 1-gang US wallbox 32-104˚F (0-40˚C) Use Lutron Claro or Satin Colors wallplates or standard decorator-style wallplates SYSTEM MAX. 32 Dimmers/Switches/GRAFIK Eye Interfaces (does not include RA-AD Accessory Dimmers or RA-AS Accessory Switches) LOAD TYPE Incandescent and magnetic low-voltage (directly) ADDL. LOADS To dim high-wattage loads or specialty loads (electronic low-voltage over 500W, fluorescent, or neon/cold cathode), use RAN-600LM with the appropriate Lutron interface: NGRX-PB, ELVI-1000, GRX-FDBI, or HP-2,4,6. Contact the Lutron Hotline for more information. MAX. CAPACITY600W (may be increased with Power Boosters) MIN. LOAD 10W AUXILIARY Use up to 9 RA-AS Accessory Switches for 3-way and 4-way CONTROLS applications For multi-gang installations, derate load capacities as follows: End of Gang Middle of Gang Model No. (1 side section removed) (2 side sections removed) RAN-600LM* 500W 400W RA-AD Does not require derating Does not require derating *No derating required when controlling Power Boosters and Interfaces. ®
TM
- Multiple location dimming from Dimmer and Accessory Dimmer. - Lights fade up or down over 3 seconds when turned on or off.
®
NOTE: In rare instances, certain lamp types can buzz or hum when dimmed. To reduce lamp buzz, use Lutron Lamp Debuzzing Coil with RadioRA Multi-Location Dimmer with Neutral.
- Double tap instantly brings lights to full on. - Long tap (press and hold for 1/2 second) fades lights to off over 10 seconds. - Light levels can be fine-tuned by pressing and holding the dimming rocker until desired light level is reached. 4 Function Allows local control of one circuit of lights in a RadioRA system to: - turn lights on or off - adjust light intensity 4 Flexibility - Uses conventional 3-way and 4-way wiring. 4 Reliability - Dimmers always operate locally and do not require central system control.
Have Questions? Call the Lutron Hotline 24/7 at 800-523-9466, or visit the Lutron website at www.lutron.com
4 Dimmer Operation
Switch Tap on/off Dimming Rocker Press to Brighten LEDs (Dimmer only) Indicate light level; glows softly as night light when light is off
IMPORTANT NOTICE: FASS™ - Front Accessible Service Switch - to replace bulb, remove power by sliding FASS switch to the left on either the Dimmer or any Accessory Dimmer.
Press to Dim Off
FASS Front Accessible Service Switch
On
TM
4 Wiring Diagrams Single-Location Installation
Multi-location Installation Dimmer
Dimmer Hot
Black
Red
Black
Hot
Red Blue
120/127VAC 50/60Hz
Green
White
Cap Off
Accessory Dimmer Red Black
Green Lighting Load
Accessory Dimmer Red
Green
Green
120127VAC 50/60Hz
Lighting Loads
White
Neutral
Blue
Blue
Blue
Notes: Use up to nine Accessory Dimmers Maximum wire run length on blue wire is 250 feet.
Neutral
Ground
Black
Wire Connectors
4 RadioRA System Overview
Master Control
Multi-Location Dimmer Notes: - RadioRA Dimmers must be located within 30 feet of an RF Signal Repeater.
Accessory Dimmer
- RadioRA Accessory Dimmers (RA-AD) are not required to be within any specific range of an RF Signal Repeater.
Single-Location Dimmer RF Signal Repeater
30 Feet
4 Limited Warranty Lutron will, at its option, repair or replace any unit that is defective in materials or manufacture within one year after purchase. For warranty service, return unit to place of purchase or mail to Lutron at 7200 Suter Rd., Coopersburg, PA 18036-1299, postage pre-paid. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND THE IMPLIED WARRANTY OF MERCHANTABILITY IS LIMITED TO ONE YEAR FROM PURCHASE. THIS WARRANTY DOES NOT COVER THE COST OF INSTALLATION, REMOVAL OR REINSTALLATION, OR DAMAGE RESULTING FROM MISUSE, ABUSE, OR IMPROPER OR INCORRECT REPAIR, OR DAMAGE FROM IMPROPER WIRING OR INSTALLATION. THIS WARRANTY DOES NOT COVER INCIDENTAL OR CONSEQUENTIAL DAMAGES. LUTRON'S LIABILITY ON ANY CLAIM FOR DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE MANUFACTURE, SALE, INSTALLATION, DELIVERY, OR USE OF THE UNIT SHALL NEVER EXCEED THE PURCHASE PRICE OF THE UNIT. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. © 2001 Lutron Electronics Co., Inc.
Order P/N 366-416 for a complete set of RadioRA specification submittals. Printed in the U.S.A. 1/02
