Transcript
Band-Specific High Power Amplifier Product Name: RCA0822H36E Doc. Name: Preliminary Short Spec.
Preliminary Short Specification for RCA0822H36E
1
RESTRICTION ON USE, DUPLICATION, OR DISCLOSURE OF PROPRIETARY INFORMATION This document contains proprietary information, which is the sole property of RFcore co., LTD. The document is submitted to the recipient for his use only. By receiving this document the recipient undertakes not to duplicate the documents or to disclose in part of, or the whole of, any of the information contained herein to any third party without receiving beforehand, written permission from the submitting company.
Created
Printed
2014/1/22
2014/1/22
Document Number
Revision
Manufacturer
H
RFcore co.,Ltd
File : RCA0822H36E ShortSpec.docx The Specifications is subject to change before finalization Customer Service: Tel. 82-31-708-7575 Email:
[email protected] http://www.rfcore.com
Band-Specific High Power Amplifier Product Name: RCA0822H36E Doc. Name: Preliminary Short Spec. ELECTRICAL SPECIFICATIONS
@ 50 Ohms load, 28 Vdc, Tc ≒ 35 ℃
Parameter
Specification
Frequency Range
Remark
Band 1: 869-960 MHz Band 2: 1805-2190 MHz
Saturated Output Power
36 dBm min.
@ CW, 50 Ohms
Gain
Band1 & Band2 : 30 dB min.
Input level = -15 dBm
Gain Flatness
Band 1 : 2.0 dB p-p
Input level = 6 dBm
Band 2 : 3.0 dB p-p Input Power for rating output
6 dBm typ.
Input dynamic range :
power Maximum
-30 dBm to 6 dBm input
power
for
no
10 dBm
damage Input VSWR
Less than 1.5 : 1
Maximum load VSWR for amplifier
Infinite, all phase
survival On/Off Switching Time
10 usec max.
Out of bandwidth attenuation if
70 dB min. @ 1710-2190 MHz
band 1 selected Out of bandwidth attenuation if
70 dB min. @ 5.725-5.75 GHz
band 2 selected
2
Isolation
60 dB min.
DC Input Voltage
28 ± 0.5 Vdc
DC Current Consumption
770 mA max.
@ Pout= 34.5 dBm
Control voltage for band select
2 mA max.
+3 ~ +5 VDC
I/O Map(micro D-sub 9pin)
1. Enable (Active Low)
Enable : OPEN or TTL Low Disable : TTL High(+3 ~ +5VDC) Pulled-down with 10 kΩ
2. Forward Power Monitor
It is output of diode detector. It has non-log slope characteristics. (0~2VDC)
3. N.C
Do not connect
4. Reflected Power Monitor
It is output of diode detector. It has non-log slope characteristics. (0~2VDC)
5. Temperature Monitor
VT= 10[mV/℃] * Tc[℃] + 500[mV], Tc = Case Temperature± 5 [℃]
6. Vcc(+28V) 7. GND 8. Band select A
Internal PA Band 1: 00(BA) Internal PA Band 2: 01(BA)
9. Band select B
External PA port: 10(BA) *Exact logic TBC
Created
Printed
2014/1/22
2014/1/22
Document Number
Revision
Manufacturer
H
RFcore co.,Ltd
File : RCA0822H36E ShortSpec.docx The Specifications is subject to change before finalization Customer Service: Tel. 82-31-708-7575 Email:
[email protected] http://www.rfcore.com
Band-Specific High Power Amplifier Product Name: RCA0822H36E Doc. Name: Preliminary Short Spec.
ENVIRONMENTAL SPECIFICATIONS Parameter
Specification
Operating Case Temperature
-20 ~ 70 ℃
Storage Temperature
-40 ~ 85 ℃
Remark
MECHANICAL SPECIFICATIONS Parameter
Specification
Dimension
126 x 70 x 20 mm
RF Input / Output Connector
MMCX – Female(2H)
Remark See the figure below
MECHANICAL DRAWING
DATE
REVISION
APP.
1
A
3
A
B
B
PA_FS_869-2190_36
1. Enable (Active Low) 2. Forward Power Monitor 3. N.C 4. Reflected Power Monitor 5. Temperature Monitor 6. Vcc (+28V) 7. GND 8. Band Select A 9. Band Select B
C TBD
CAN BUS 9 5
RF OUT
8 4
7 3
6 2
C
MAIN 9 1
5
8 4
7 3
6 2
1
RF IN
EXT. PA
D
D
CAN BUS
MAIN
RF OUT
RF IN
EXT. PA
E
E
MATERIAL
FINISH
UNIT
Q'ty
ANGLE
mm
F
DESIGNED 기구 설계
Youngseon
회로
2
Created
Printed
2014/1/22
2014/1/22
3
4
Document Number
5
6
APPROVED
7
SCALE
1 : 1
F
FILE PATH
-
MODEL NO.
RCA0822H36E
MODEL NAME
DUPLEXER + HPA
PART NAME
OUTLINE DRAWING
DRAWGING NO. -
설계
1
CHECKED
1 / 1
8
Revision
Manufacturer
H
RFcore co.,Ltd
File : RCA0822H36E ShortSpec.docx The Specifications is subject to change before finalization Customer Service: Tel. 82-31-708-7575 Email:
[email protected] http://www.rfcore.com
