Transcript
PATIO INSTALLATION INSTRUCTIONS STAINLESS STEEL KITCHEN SINKS K-3084T
· · ·
· ·
WARNING: Risk of personal injury. Metal surfaces are sharp and can cause severe cuts. Use gloves and handle sink edges carefully. Observe all local plumbing and building codes. Shut off the hot and cold water supplies. Prior to installation, unpack the new sink and inspect it for damage. Return the sink to its protective carton until you are ready to install it. Inspect the drain and supply tubing. Replace if necessary. All information in these instructions is based on the latest product information available at the time of publication. Kohler china..reserves the right to make changes at any time without notice.
· · ·
· ·
RECOMMENDED TOOLS AND MATERIALS Measuring Tape Pencil Drill Putty Knife Silicone Sealant Pipe Wrench Plumbers Putty
· · · · · · · ·
Plus: · Level · Cross Screwdriver · Keyhole/Jigsaw · Gloves
· · · ·
· · · · · · · ·
Safety Glasses
106
1095140-T01-A
-1-
2
324528137
200131 , 2008 Copyright Kohler China Ltd., 2008
ROUGHING-IN Countertop
Unit: mm
508
483 Cut-out Sink
787 838
Drop-In Installation
INSTALLATION THE NEW SINK 1. Preparation
1.
NOTE: You may require different, more specialized tools to install this sink to countertop materials other than wood or wood composites. · Measure the thickness of the countertop. · Determine the threaded length of the faucet. · Compare the measurements to verify that the faucet will fit on the countertop as required. If the faucet will not fit, you will need to select a different faucet or countertop. · Install the water supplies and drain piping according to the roughing-in information. · Cut along the dotted line on the template, taking care to cut accurately. This is the outside profile of the sink. · Determine the exact installation location of the sink using the template. · Use tape to secure the template in place in the desired installation location. · Carefully cut through the countertop with a jigsaw or keyhole saw following the inside solid line on the template. Take special care when cutting out the corners.
· · ·
· · · · ·
Backsplash
Secure template with tape.
1095140-T01-A
-2-
2. Install the Sink
2.
· Place the sink upside down and loosely attach two mounting clips on the left side of the sink using fasteners. · Install the faucet and drain according to the manufacturer's instructions. · Apply a bead of quality sealant to the underside of the sink rim. · Lower the right side of the sink into place. · Attach the mounting clips to the right side of the sink. · Evenly tighten the mounting clip screws using a Phillips screwdriver. · Wipe away any excess sealant from the countertop with a dry cloth. · Verify that there are no gaps. · Allow the sealant to cure for at least 30 minutes before proceeding. · Install the garbage disposal, if desired. Follow the manufacturer's instructions. · Connect and tighten the trap to the drain, and complete the water supply connections to the faucet according to the instructions packed with the faucet. · Run water into the sink and check for leaks. · Clean up with a non-abrasive cleaner.
· · · · · · · · · · ·
· ·
Mounting Bracket Fastener
Apply Sealant (Not Furnished) ( )
Countertop Opening-Bottom View -
Sink
Countertop Mounting Bracket
1095140-T01-A
-3-
Fastener
CARE AND CLEANING Stainless Steel Rinse your stainless steel sink thoroughly after each use, and use a dabbing action to dry with a clean, soft cloth. Clean stainless steel once a week. Always apply stainless steel cleaner/polish with a nonabrasive cloth or sponge, working with, not across the grain. Do not use steel wool, wire brushes or abrasive pads to clean your sink.
/
If you use cleaners containing chlorides, be sure to rinse the surface immediately after you clean it to avoid corrosion. Do not allow cleaners to remain in contact with the sink surface for long periods of time. Kohler kitchen sink accessories, including bottom basin racks, wire rinse baskets, cutting boards and colanders will help protect the surface of your sink. If the surface becomes excessively dirty, consider using baking soda, or a general purpose cleaner.
1095140-T01-A
-4-
