Preview only show first 10 pages with watermark. For full document please download

Red Fang™ 16 - Costruire Audio

   EMBED


Share

Transcript

Specification Nominal Basket Diameter Nominal Impedance* Power Rating** Resonance Usable Frequency Range*** Sensitivity Magnet Weight Gap Height Voice Coil Diameter 12”, 304.8mm 16 ohms 30W 89Hz 70Hz-6kHz 100.3 35 oz. 0.312”, 7.92mm 1.75”, 44.5mm The Art and Science of Sound Thiele & Small Parameters Resonant Frequency (fs) DC Resistance (Re) Coil Inductance (Le) Mechanical Q (Qms) Electromagnetic Q (Qes) Total Q (Qts) Compliance Equivalent Volume (Vas) Peak Diaphragm Displacement Volume (Vd) Mechanical Compliance of Suspension (Cms) BL Product (BL) Diaphragm Mass inc. Airload (Mms) Efficiency Bandwidth Product (EBP) Maximum Linear Excursion (Xmax) Surface Area of Cone (Sd) Maximum Mechanical Limit (Xlim) 89Hz 11.4 0.71mH 8.93 1.09 0.97 50.2 liters / 1.8 cu. ft. 25cc 0.13mm/N 12.0 T-M 24 grams 82 0.5mm 519.5 cm2 RED FANG™ 16 red fang n. a 12” guitar speaker with unique British voicing, a large alnico magnet, smooth distortion and rich harmonics Coloration: Vintage British sound with warm undertones and high-end sparkle Genre: Vintage classic British tone for Blues, Country, Indie and Jazz Mounting Information Recommended Enclosure Volume Sealed Vented Overall Diameter Baffle Hole Diameter Front Sealing Gasket Rear Sealing Gasket Mounting Holes Diameter Mounting Holes B.C.D. Depth Net Weight Shipping Weight Acceptable Acceptable 12.02”, 305.3mm 10.97”, 278.6mm fitted as standard fitted as standard 0.25”, 6.4mm 11.63”, 295.4mm 6.2”, 158mm 9.3 lbs., 4.2 kg 11.1 lbs., 5 kg Materials of Construction Copper voice coil Nomex former Alnico magnet Non-vented core Pressed steel basket Paper Cone Paper cone edge Zurette dust cap * Please inquire about alternative impedances. ** Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment. *** The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms. Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25” supplied microphone (software calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with fiberglass on all six surfaces (three with custom-made wedges)