Preview only show first 10 pages with watermark. For full document please download

Replacement Air Filter For The 8820 Grandslam And Broadband Access Concentrator Installation Instructions

   EMBED


Share

Transcript

Replacement Air Filter for the 8820 GranDSLAM and Broadband Access Concentrator Installation Instructions Document Number 8820-A2-GZ46-10 June 2004 What is the Air Filter? The air filter prevents dust from entering the 8820 GranDSLAM chassis (Model 8820-A1-500) or the 8820 Broadband Access Concentrator (Model 8820-A2-500). Install an air filter when the chassis is in a dusty or unfiltered environment. Once the filter is installed, you should inspect the air filter once a year, and replace it when dirty, whenever the fan alarm is active, or when the fan tray is being serviced or replaced. Do not attempt to clean the filter; when dirty, it should be replaced. CAUTION: A clogged air filter will cause a rise in temperature, which could damage the equipment. 8820-A2-GZ46-10 June 2004 1 Installing the Replacement Air Filter in the 8820 GranDSLAM Chassis, Model 8820-A1-500 You will need a Phillips screwdriver to remove the fan tray cover plate. Procedure To install the replacement air filter: 1. Remove the three screws that hold the vent cover plate to the chassis. 2. Pull down on the vent cover plate to remove it from the chassis. 3. Remove the old air filter by sliding it forward out of the filter brackets. POWER A SYST SYSTE EM Fan Major Minor M OK OK Alm Alm Test Test ETHER NET ETHERN ET TX TX DSL ALARMS B RX RX Coll Coll PORT 1 2 3 4 MCP -48V (B) POWER ENTRY MODULE LEFT UNIT: LINE A RIGHT UNIT: LINE B -48V (A) -48V (B) POWER ENTRY MODULE LEFT UNIT: LINE A RIGHT UNIT: LINE B -48V (A) DSL CLOCK SERIAL AC A MCC ALARM B SERIAL ALARM CLOCK SMCM 2 4 6 8 1 3 5 7 LAN/WAN SLOT 10 A 9 B 12 14 16 18 11 13 15 17 Vent Cover Air Filter 00-15425a 4. Slide the replacement air filter into the filter brackets, until it seats against the foam strip on the backplane. NOTE: When oriented properly, the arrows on the sides of the filter point up. 5. Replace the vent cover plate and secure it to the chassis with three screws. 2 June 2004 8820-A2-GZ46-10 Installing the Replacement Air Filter in the 8820 Broadband Access Concentrator (BAC), Model 8820-A2-500 Procedure To install the replacement air filter: 1. Unfasten the three screws on the vent cover plate and remove it. 2. Remove the old air filter by sliding it forwards and down. 3. The air filter mounts at an angle within the chassis. Slide the air filter upwards into the air filter guides, located on the inside of each side wall, until the air filter seats against the foam strip located on the backplane. POWER A ALARMS B Fan Major Minor SYS TEM SYST EM OK Alm OK Test Alm Test ETHE RNET ETHER NET TX RX TX Coll RX Coll DSL PORT 1 2 3 4 POWER ENTRY MODULE LEFT UNIT: LINE A RIGHT UNIT: LINE B 48V NEG POWER ENTRY MODULE LEFT UNIT: LINE A RIGHT UNIT: LINE B 48V NEG MCP 48V RTN 48V RTN DSL CLOCK SERIAL AC A MCC ALARM 2 4 6 8 B SERIAL ALARM CLOCK SMCM 1 3 5 7 LAN/WAN SLOT A 10 12 14 16 18 11 13 15 17 WARNING! POWER MUST BE DISCONNECTED AT THE SOURCE BEFORE REMOVING OR INSTALLING THIS PWR ENTRY MODULE WARNING! POWER MUST BE DISCONNECTED AT THE SOURCE BEFORE REMOVING OR INSTALLING THIS PWR ENTRY MODULE 9 B Vent Cover Air Filter 00-15425-05 NOTE: When oriented properly, the vertical arrows on the front and rear edges of the filter point up. 4. Replace the vent cover plate, ensuring that the plate’s foam strip presses against the front of the filter. 5. Replace the three screws. 8820-A2-GZ46-10 June 2004 3 Warranty, Sales, Service, and Training Information Contact your local sales representative, service representative, or distributor directly for any help needed. For additional information concerning warranty, sales, service, repair, installation, documentation, training, distributor locations, or Paradyne worldwide office locations, use one of the following methods: „ Internet: Visit the Paradyne World Wide Web site at www.paradyne.com. (Be sure to register your warranty at www.paradyne.com/warranty.) „ Telephone: Call our automated system to receive current information by fax or to speak with a company representative. — Within the U.S.A., call 1-800-870-2221 — Outside the U.S.A., call 1-727-530-2340   .  *8820-A2-GZ46-10* Copyright © 2004 Paradyne Corporation. Printed in U.S.A. 4 June 2004 8820-A2-GZ46-10