Rf Rgbw Wall Mounted Controller

Transcript

Product Data RF RGBW Wall Mounted Controller AC Version Important: Read All Instructions Prior to Installation Function introduction Click to choose zone, Press and hold down to turn on/off corresponding zone Output Signal RF signal Power Supply 100-240VAC Power consumption 15 mA Operating temperature 0-40°C Relative humidity 8% to 80% Dimensions 86x86x29.1mm LED indicator • Touch sensitive Press and hold down to save colors/scenes; Click to recall the saved colors/scenes Click to turn on/off all zones. Click zone button(1/2/3/4), Then press and hold down to increase/decrease light intensity of the chosen zone Click to play / pause the 10 built-in effects, Press and hold down to speed up/down the running effects • Glass interface(white & black) Touch color wheel, touch to select R/G/B color • Waterproof grade: IP20 • Compatible with all universal series RF receivers • Control RGBW color • Control 4 zones synchronously and separately Safety & Warnings • DO NOT install with power applied to device. • DO NOT expose the device to moisture. Wiring diagram R/G/B/W 4channels:Click to turn off/on the channel Press and hold down to increase/decrease light intensity of each channel AC Version Front side AC Version 60.3 mm 52.0 mm 19.4 mm RF Wall Panel Controller L N 52.0 mm 60.3 mm AC Version RF Wall Panel Controller L N AC Power 50/60Hz AC 100-240V AC Power input Back side Pair with RF receivers: Turn on the wall Click “Learning Key” panel controller on RF receiver LED lights connected with the RF receiver will flicker once Click a zone number on the wall panel controller:1/2/3/4 Touch the color wheel The receiver is paired with the remote successfully. How to delete the pairing: Press and hold down “Learning Key” on the receiver for over 3 seconds until connected LED lights flicker twice, which means the pairing is deleted successfully. Save color/scene/mode: Turn on the wall Click one of the paired panel controller zone numbers Operation the buttons to select a color /mode you like Immediately click any of the zone numbers that you would like to save the color/scene to Press and hold down button S until the LED indicator flashes once The connected LED light with DMX decoder/RF receiver will flash The color/scene is saved successfully. Recall the saved colors/scenes: Turn on the wall panel controller Click any of the zone numbers you would like to recall the scene/color Installation DC version needs connect with DC power supply 1 Po 2-2 w 4V er D Su C pp l y Click button S Click the zone number again to recall the saved.