Preview only show first 10 pages with watermark. For full document please download

Rm 28

   EMBED


Share

Transcript

Rack Mounting Kit for 19-inch Racks http://www.CBNETWORKS.fr - E-Mail: [email protected] - Tel: 33 (0)1 77 55 03 00 RM-28 RM Kits for Installation of One or Two 1U High Units KIT CONTENTS Rack adapter components for installing a single unit include: • One short left side bracket • One long right side bracket Rack adapter components for installing two units include: • One short left side bracket • One short right side bracket • 8 screws • Four screws • Two bottom braces EQUIPMENT NEEDED • A 3 mm Phillips screwdriver • Four 5 mm Phillips screws. INSTALLATION Disconnect all cables including the power cord from the unit before performing the installation procedures. Warning ➤ To install a single unit: 1. Align the lower section of the short bracket with the recess on the bottom panel at the left side of the unit. 2. Insert the lead tab of the short bracket into the slot of the bottom panel recess. 3. Fasten the short bracket to the left side of the unit by two screws which are inserted into the two holes: one on the side panel, another on the bottom panel (see Figure 1). The unit is supplied with nuts already in place on the inner wall. 4. Repeat step 1 to step 3 to fasten the long bracket to the right side of the unit. Once the brackets are fastened to the side walls, the unit is ready for installation in the 19-inch rack. 5. Place the unit in the rack and fasten the brackets to the side rails of the rack using two screws on each side (not included in the kit). http://www.CBNETWORKS.fr - E-Mail: [email protected] - Tel: 33 (0)1 77 55 03 00 Rack Mounting Kit for 19-inch Racks RM-28 RM Kits for Installation of One or Two 1U High Units Figure 1. Installing a Single Unit http://www.CBNETWORKS.fr - E-Mail: [email protected] - Tel: 33 (0)1 77 55 03 00 Rack Mounting Kit for 19-inch Racks RM-28 RM Kits for Installation of One or Two 1U High Units ➤ To install two units: 1. Attach the short left and right side brackets to the corresponding sides of the two units, as explained in step 1 to step 3 on the single unit installation procedures (see Figure 2). 2. Turn the units upside down. 3. Fasten the two units together by using the bottom braces and the four screws (see Figure 3). Make sure that lead tabs of the braces enter the corresponding slots on the bottom panels. 4. Place the two-unit assembly in the rack and fasten the brackets to the side rails of the rack using two screws on each side (not included in the kit). Figure 2. Attaching Side Brackets http://www.CBNETWORKS.fr - E-Mail: [email protected] - Tel: 33 (0)1 77 55 03 00 Rack Mounting Kit for 19-inch Racks RM-28 RM Kits for Installation of One or Two 1U High Units Figure 3. Fastening Two Units Together http://www.cbnetworks.fr  2002 RAD Data Communications Ltd. 12 avenue des prés 78059 St Quentin en Yvelines Tel: 33 (0)1 77 55 03 00 Fax: 33 (0)1 30 44 11 95 E-mail: [email protected] 190-216-08/02 Specifications are subject to change without prior notice.