Transcript
RM-33-2 RM Kit for Installation of 8.5" Unit(s)
KIT CONTENTS •
One tray shelf
•
Four self-tapping screws
•
Four 5-mm rack mounting screws
EQUIPMENT NEEDED •
Warning
One 3-mm Philips screwdriver
Disconnect all cables including the power cord from the unit before performing the installation procedures.
To install a single unit: 1. Place the unit on the tray shelf, aligning the bottom panel holes of the unit with the corresponding holes on the left or right side of the tray. Make sure that the tabs at the back edge of the tray shelf hold down the lower rim of the unit’s bottom panel. 2. Secure the unit on the tray shelf using the self-tapping screws. 3. Place the shelf assembly into the rack and fasten the tray shelf to the side rails of the rack using two rack-mounting screws on each side (not included in the kit).
Figure 1. Installing One Unit
Innovative Access Solutions
RM-33-2 RM Kit for Installation of 8.5" Unit(s)
1.
2. 3.
Place the units side by side on the tray shelf, aligning the bottom panel holes of the unit with the corresponding holes of the tray. Make sure that the tabs at the back edge of the tray shelf hold down the lower rim of the unit’s bottom panel. Secure the units on the tray shelf using the self-tapping screws. Place the shelf assembly into the rack and fasten the tray shelf to the side rails of the rack using two rack-mounting screws on each side (not included in the kit).
Figure 2. Installing Two Units
190-227-06/07 Specifications are subject to change without prior notice. © 1988–2007 RAD Data Communications Ltd. All other trademarks are the property of their respective holders.
To install two units:
