Transcript
http://www.CBNETWORKS.fr - E-Mail:
[email protected] - Tel: 33 (0)1 77 55 03 00
Rack Mounting Kit for 19-inch Racks
RM-34 RM Kit for Installation of One 19-inch Unit
KIT CONTENTS •
Two short brackets
•
Six flat-headed screws
•
Four 5 mm Philips screws
EQUIPMENT NEEDED •
A 3 mm Philips screwdriver
INSTALLATION
Warning
Disconnect all cables including the power cord from the unit before performing the installation procedures.
To install one unit: 1.
Attach a bracket to the side wall near the front panel of the unit (see Figure 1).
2.
Fasten the bracket to the side wall using three screws provided.
3.
Repeat steps 1 and 2 for the other bracket.
4.
Fasten the brackets to the side rails of the 19-inch installation racks using four screws, flat washers and nuts (not supplied in the kit).
Fastening Screws (3 Places)
Brackets
Fastening Screws (3 Places)
Figure 1. Installing a Unit in 19-inch Racks
http://www.CBNETWORKS.fr - E-Mail:
[email protected] - Tel: 33 (0)1 77 55 03 00
Rack Mounting Kit for 19-inch Racks
RM-34 RM Kit for Installation of One 19-inch Unit
data communications www.rad.com International Headquarters 24 Raoul Wallenberg Street Tel Aviv 69719, Israel Tel: (972) 3-6458181 Fax: (972) 3-6498250, 6474436 Email:
[email protected]
http://www.cbnetworks.fr 2003 RAD Data Communications Ltd.
12 avenue des prés 78059 St Quentin en Yvelines Tel: 33 (0)1 77 55 03 00 Fax: 33 (0)1 30 44 11 95 E-mail:
[email protected]
U.S. Headquarters 900 Corporate Drive Mahwah, NJ 07430 Tel: (201) 529-1100 Toll free: 1-800-444-7234 Fax: (201) 529-5777 Email:
[email protected] 190-223-09/03
Specifications are subject to change without prior notice.
