Preview only show first 10 pages with watermark. For full document please download

Rm-34, Rm-34/a, Rm-34/etsi, Rm-34-23

   EMBED


Share

Transcript

Mounting Kit RM-34, RM-34/A, RM-34/ETSI, RM-34-23 RM Kits for Installation of One 19-inch Unit KIT CONTENTS • Two short brackets • Six flat-headed screws EQUIPMENT NEEDED • 3 mm Philips screwdriver • Four 5 mm Philips screws INSTALLATION PROCEDURE Disconnect all cables including the power cord from the product unit before performing the mounting procedures. Warning  To install one unit: 1. Attach a bracket to the side wall near the front panel of the unit (see Figure 1). 2. Fasten the bracket to the side wall using three screws provided. 3. Repeat steps 1 and 2 for the other bracket. 4. Fasten the brackets to the side rails of the 19-inch installation racks using four screws, flat washers and nuts (not supplied in the kit). Note • RM-34/A kit allows unit installation 100 mm (3.9 in) deeper into the 19” racks. • RM-34-23 kit allows unit installation into the 23” racks. Mounting Kit RM-34, RM-34/A, RM-34/ETSI, RM-34-23 RM Kits for Installation of One 19-inch Unit Brackets Fastening Screws (3 Places) Figure 1. Attaching Brackets to Side Panels International Headquarters 24 Raoul Wallenberg Street Tel Aviv 69719, Israel Tel. 972-3-6458181 Fax 972-3-6498250, 6474436 E-mail [email protected] www.rad.com North America Headquarters 900 Corporate Drive Mahwah, NJ 07430, USA Tel. 201-5291100 Toll free 1-800-4447234 Fax 201-5295777 E-mail [email protected] Order this publication by Catalog No. 803446 190-223-12/13 Specifications are subject to change without prior notice.  1988–2013 RAD Data Communications Ltd. The RAD name, logo, logotype, and the terms EtherAccess, TDMoIP and TDMoIP Driven, and the product names Optimux and IPmux, are registered trademarks of RAD Data Communications Ltd. All other trademarks are the property of their respective holders. Fastening Screws (3 Places)