Preview only show first 10 pages with watermark. For full document please download

Rm Optimux T3

   EMBED


Share

Transcript

http://www.CBNETWORKS.fr - E-Mail: [email protected] - Tel: 33 (0)1 77 55 03 00 Rack Mounting Kit for 19-inch and ETSI Racks RM-OPTIMUX-T3 RM Kit for Installation of One Unit KIT CONTENTS • • Two short brackets Four flat-headed screws EQUIPMENT NEEDED • A 3 mm (0.12-inch) Phillips screwdriver • Four 5 mm (0.2-inch) Phillips screws. INSTALLATION Warning Disconnect all cables including the power cord from the unit before performing the installation procedures. Optimux-T3 can be installed in the 19-inch or ETSI-type racks. ➤ To install Optimux-T3 in 19-inch racks: 1. Attach a bracket to the side wall near the front panel of the unit (see Figure 1). 2. Fasten the bracket to the side wall using two screws provided. 3. Repeat steps 1 and 2 for the other bracket. 4. Fasten the brackets to the side rails of the 19-inch installation racks using four screws, flat washers and nuts (not supplied in the kit). Brackets Fastening Screws (4 Places) Figure 1. Installing Optimux-T3 in 19-inch Racks http://www.CBNETWORKS.fr - E-Mail: [email protected] - Tel: 33 (0)1 77 55 03 00 Rack Mounting Kit for 19-inch and ETSI Racks RM-OPTIMUX-T3 RM Kit for Installation of One Unit ➤ To install Optimux-T3 in ETSI racks: 1. Attach a bracket to the side wall near the rear panel of the unit (see Figure 2). 2. Fasten the bracket to the side wall using two screws provided. 3. Repeat steps 1 and 2 for the other bracket. 4. Fasten the brackets to the side rails of the ETSI racks using four screws, flat washers and nuts (not supplied in the kit). Brackets Fastening Screws (4 Places) Figure 2. Installing Optimux-T3 in ETSI Racks http://www.cbnetworks.fr  2001 RAD Data Communications Ltd. 12 avenue des prés 78059 St Quentin en Yvelines Tel: 33 (0)1 77 55 03 00 Fax: 33 (0)1 30 44 11 95 E-mail: [email protected] 190-215-11/01 Specifications are subject to change without prior notice.