Transcript
ASSEMBLY INSTRUCTIONS FOR RMCS/RMCV UNITS
RMCS/RMCV - SERIES
BUL10226 REV. E PAGE 1 OF 1
Note: For 1 unit high cabinet use internal corner brackets typical 4 corners. See step A
7 3 1
Ensure brakets (item 1) are oriented correctly
4 2
6
1
7 7
6 2 4
5 Rack mounting brackets typical each side
7 8
ASSEMBLY INSTRUCTIONS:
3
ITEM No. 1 2 3 4 5 6 7 8
PARTS LIST DESCRIPTION INTERNAL RAILS OR CORNER BRACKETS SIDES TOP/BOTTOM PANELS FRONT/REAR PANELS RACKMOUNTING BRACKETS 10-32 MACHINE SCREWS 6-32 X 3/8 PH SCREWS RUBBER FEET (SELF ADHESIVE)
TOOL BOX
#2 Phillips Screw Driver
1 UNIT HIGH CABINET
A) Assemble sides (item 2) to the interna l rails (item 1) or internal corner brackets (1 unit high) using 10-32 x 1/2 machine screws (item 6) as shown. Ensure holes on internal rails face out and extra holes on sides are at the bottom.
QTY
B) For rack mounting install rack mounting brackets (item 5) to sides. Optional handles can also be used with brackets (but may interf ere with rack installation)
4 2 2 2 2 8 16 4
C) Fasten top and bottom panels (item 3) to the interna l rails (item 1) using 6-32 x 3/8 screws (item 7) as shown. D) Fasten front and rear panels (item 4) to the interna l rails (item 1) using 6-32 x 3/8 screws (item 7) as shown. E) Install rubber feet (item 8), (self adhesive), in desired location on bottom if required.
HAMMOND MANUFACTURING
TM
ELECTRONICS GROUP visit our website @ www.hammondmfg.com
