Rmm+ Installation Guide For Themro King Mp-4000

Transcript

RMM+ installation guide for Thermo King MP-4000 unit Rev. 130316 Electrical ratings and requirements Product Supply Ratings: – Power Supply: 24 VAC +20/-30% 50-60 Hz or 24-41 VDC – Power consumption max: 36 VA Power line communication voltages ratings: – Rated voltage 440 V, 3 Phases +20/-30% – Frequency: 50-60Hz – Power consumption max: 0.1 A Disconnect Device: – This product requires a disconnect device. The disconnect device must be easily accessible by the service personnel. – This product requires an external over current protection device. – Maximum allowable fuse size is 32 A. Fuse: Warning: – This product is for intended use only in a restricted access location. Access can only be gained by SERVICE PERSONS or by USERS who have been instructed about the reasons for the restrictions applied to the location and about any precautions that shall be taken – This product is for build in only, and requires a suitable electrical and fire enclosure in the final place of installation. Minimum fire requirement for electrical enclosure is UL 94 V-2. Warning for improper use of rechargeable battery: – Only replace with rechargeable Emerson battery of same type CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTION 2 Caution!  Make sure that power is off, unit is disconnected and that no parts inside the unit are damaged during the installation CHECK CONTAINER ID: Container ID in the container controller must be correct – verify and correct if necessary. CHECK CONTROLLER SOFTWARE: It is strongly recommended to update to latest controller software: Minimum required controller sw: 2.5.1.0 3 RMM+ installation guide for Thermo King MP-4000 unit Requirement: • RMM+ Kit (Rmm+, antenna, 4 screws, warning label) • Side cutting pliers. • Cable binders • Screwdrivers (Torx 15 & 20) RMM+ kit: RMM+ unit and combined Bluetooth/GPRS/GPS antenna with cable and connectors. 4 RMM+ installation guide for Thermo King MP-4000 unit 1: Unpack all components. 2. Disconnect the reefer container from power. 3. Remove the MP-4000 Li-Ion battery as shown below. 4: Locate the mounting place for the antenna, and install the antenna using the included screws 5 RMM+ installation guide for Thermo King MP-4000 unit 5. Install the RMM+ in the left side expansion slot, as shown in picture, and guide the cables. 6. Use Cable ties to fasten the cable. 7. Reinstall MP-4000 battery 6 RMM+ installation guide for Thermo King MP-4000 unit 8. Connect the plugs for the antenna by matching the colors. Make sure no cables are with tension. 9. Guide the cable from the antenna to the RMM+ device, use cable ties to secure that cables cannot kink. 10. Reconnect power and turn on the unit. LED´s on RMM+ will light up when appropiate signal is detected. See matrix on next page for verification. 7 RMM+ installation guide for Thermo King MP-4000 unit Please note that it can take several minutes to obtain GSM and GPS connection. When GPS fix and server connection is established, then both LED´s will light steady LED`s Steady OFF Flashing Position (Green color) Accurate GPS fix No satelites Inaccurate position Telecommunic Network detected No Network ation and connection (Green color) to Global Monitoring Server established Bluetooth (Blue Color) No short range activity Short Range activity Now the installation is done ! 8