Roboreel® Quick Start Guide:

Transcript

Roboreel® Portable Air Hose Reel 1-888-GR8-STUFF Quick Start Guide – Page www.roboreel.com 1 IF YOU HAVE ANY QUESTIONS OR DIFFICULTIES CALL OUR CUSTOMER SUPPORT TEAM: 1-888-GR8-STUFF Reel Parts Diagram 1. Connect Power 1. Plug Power Entry Cable securely into AC outlet. * The unit will emit a tune, indicating it is ready to use 2. Connect Air Supply 1. Connect Air Input Hose to air supply CAUTION: DO NOT EXCEED 300 PSI PRESSURE 3. Connect Air Tool 4. Remove Tool / Retract Hose 1. Connect air tool / device to Quick Coupler 1. Disconnect tool from Quick Coupler by pulling down then pushing upward on coupler. 2. Extract hose / tool to desired working length 2. Press Remote or Dome Retract Button to reel in hose then push pull first CAUTION: The Air Hose System is rated for dry, indoor use only. DO NOT OPERATE IN WET ENVIRONMENT This Quick Start Guide does not replace the User Guide. For complete details and precautions concerning this product, read all instructions in the User Guide provided Doc. No. 070-000139-01, Rev 1 Roboreel® Portable Air Hose Reel 1-888-GR8-STUFF Quick Start Guide – Page www.roboreel.com 2 IF YOU HAVE ANY QUESTIONS OR DIFFICULTIES CALL OUR CUSTOMER SUPPORT TEAM: 1-888-GR8-STUFF 5. Bench Mount (included) Instructions 1. Attach Bench Mount Bracket to work surface using two (2) black wood screw (included) as shown in Fig 1a 2. Insert leg bar into mount (1) and then pull reel forward to secure it (2) 6. Program the Slow-Down Point The reel may be setup to slow down the hose retraction speed at a desired distance from the unit (the “docking” point) to prevent whipping action of the hose To set the slow down (docking) point: Wood Screws Wall Mount (optional) Instructions 1. Connect the unit to power and air supply (fully retract the hose into unit) 2. Extract the hose until the Quick Coupler and Remote Retract Button Module are resting on the floor at the desired slow-down length. 3. Press and hold either the Remote or Dome Retract Button for approximately 5 seconds. Once programming is complete, the unit will begin to reel in (release the button / hose) 4. FULLY extract the hose all the way out and retract the hose to test slow-down point. Repeat steps 2-4 to change the slow-down point. The reel may be wall-mounted using the optional wall mount bracket kit (purchased separately). Complete mounting instructions are included with the bracket kit. Bracket Wall Press and hold Retract Button at desired location This Quick Start Guide does not replace the User Guide. For complete details and precautions concerning this product, read all instructions in the User Guide provided