Transcript
RSR6
Information and advice CAUTION:Accessibie parts may become hot when used with cooking appliances.
must
has been used.
light a flame
oil splashing and becoming a fire hazard.
Attention ! Observe the warning in the instruction sheet concerning the operation of the appliance when air is discharged from the room
˄metal grill with grease filter optional˅
A B
2
A B
3
Vertical discharge Vertical isWe therecommend most common. that after If you select this venting direction, installation the bottom of you only need to open the knockout A.Remove the theducting hood should be no less ducting knockout by inserting Flat head than 650mm and noamore screwdriver under one above end and than 750mm theprying it up. Then snip or break the heating attachment points by tin snips. stove's elements You mustand make sure that the ducting knockout B is burners. not removed.
Horizontal discharge that after AssumingWe thatrecommend the range hood is located against an installation thedischarge bottom ofis preferred outside wall, horizontal the hood no less such as, wall provided that thereshould are no be obstructions than 650mm and nodifficult more to make. joints, or where openings are thanthis 750mm above the you only need to If you select venting direction, elements open the stove's ducting heating knockout B. and burners.the ducting knockout A, you must Same with removing make sure that the ducting knockout A is not removed.
Information Sufficient air is needed for proper combustion and exhausting of gases through the fule (chimney) of fuel burning equipment to prevent back drafting.
to
*3/8"nut driver
holes, in case the front and back of hood moves, so that the user is safe.
fastened enough.
ss
Security hole
Security hole
and back of hood moves, so that the user is safe.
in the
Information
14 ·It is recommendable to clean the metallic filter every three months by carrying out the following instructions: -Remove the metallic filter from the cooker hood and wash it in a solution of water and neutral liquid detergent, leaving to soak -Rinse thoroughly with warm water and leave to dry. -The metallic filter may also be washed in the dishwasher. The metallic filter may alter in colour after several washes. This is not cause for customer complaint nor replacement of metallic filter.
There is a fire risk if cleaning is not carried out in accordance with the instructions.
The manufacturer shall decline all responsibility if the foregoing recommendations and instruction regarding installation, maintenance and use are not observed and respected when using the cooker hood.
