Transcript
Errata to the RV Series Remote Control Owner’s Manual
Errata RC/GS 976-0212-01-01 Rev A
This errata applies to the RV Series Remote Control Owner’s Manual (Document Part Number 975-0210-01-01 Revision A). The following correction applies throughout the manual: •
The Charge and Batt. Full LED indicators are orange (not yellow). Inverter Charge Batt. Full
Green Orange Orange Red
Error
Charge LED Indicator The Charge LED indicator table on page 27 has the following corrections: • •
The Charge LED indicator is solid during absorption and float charging (not flashing). The Charge LED indicator is flashing during equalize charging (not fast flashing).
RC/GS
Charge LED Indicator
Other LED Indicators or Devices
Meaning
Solid
Bulk charging
Solid
Absorption charginga
Solid
Batt. Full LED indicator solid
Float charging
Flashing
Equalize charging
Off
No charging a.The Batt. Full LED indicator will be solid when the battery state-ofcharge (SOC) is between 90 and 100% according to the inverter/ charger's estimate. See “Absorption Charging” on page 3 and in the owner’s manual.
Batt. Full LED Indicator The Batt. Full LED indicator table on page 28 has the following correction: •
The Batt. Full indicator LED is solid when the battery is charged 90% or higher (not flashing). Batt. Full LED Indicator Other LED Indicators or Devices
Meaning
Solid
Battery fully charged (100%)
Solid
Charge LED indicator solid
Off
Battery charged 90% or higher Battery below 90% charge
Inverter Mode Messages The “Note” callout on page 34 of this section has the following correction: •
The LED indicator does not flash during the charge mode if the inverter is turned on.
Note: The Inverter LED indicator does not flash during the charge mode if the inverter is turned on. The Inverter LED indicator turns off if the inverter is turned off.
2
976-0212-01-01
Errata
Charger Mode Messages The following subsections of “Charger Mode Messages” have corrections.
Absorption Charging “Absorption Charging” on page 35 has the following corrections: • •
In Absorption mode, the Charge LED indicator is solid (not flashing). When the battery reaches 90% state-of-charge, the Batt. Full LED indicator will be solid (will not flash). The following text replaces the paragraph under “Absorption Charging” on page 35. When the charger is charging in Absorption mode, the screen displays Absorption Chg, and the Charge LED indicator is solid. In addition, the Batt. Full LED indicator will be solid when the battery state-of-charge (SOC) is between 90 and 100% according to the inverter/charger's estimate.
Float Charging “Float Charging” on page 36 has the following correction: • In Float mode, the Charge LED indicator is solid (not flashes quickly). The following text replaces the paragraph under “Float Charging” on page 36. When the charger is in Float mode, the screen displays Float Charging, and the Charge LED indicator is solid. At this point the batteries are fully charged (100%) and the Batt. Full LED indicator is solid.
Equalizing Charging The paragraph under “Equalizing Charging” on page 36 has the following correction: •
976-0212-01-01
In equalize mode, the Charge LED indicator flashes approximately two times per second (not 8 times).
3
RC/GS
The following text replaces the first paragraph under “Equalizing Charging” on page 36. To activate Equalize mode, press and hold the Settings button (right arrow) until the screen clears and Equalizing appears (approximately 6 seconds). The Charge LED indicator flashes approximately two times per second in equalize mode. The equalize charge will continue for 3 hours, and then automatically change back to float charging. Xantrex and XPower are trademarks of Schneider Electric Services International sprl, registered in the U.S. and other countries. Other trademarks, registered trademarks, and product names are the property of their respective owners and are used herein for identification purposes only.
Trademarks
Errata to the RV Series Remote Control Owner’s Manual © February 2009 Xantrex Technology Inc. No part of this document may be reproduced in any form or disclosed to third parties without the express written consent of: Xantrex Technology Inc. 161-G South Vasco Road Livermore, California USA 94551 Xantrex Technology Inc. reserves the right to revise this document and to periodically make changes to the content hereof without obligation or organization of such revisions or changes unless required to do so by prior arrangement. All warranty, disclaimer and safety information is contained within the primary documentation received with your unit. Please ensure you are familiar with that information before proceeding.
Notice of Copyright
Date and Revision February 2009 Rev A Contact Information Telephone: Fax: Email:
4
Part Number
976-0212-01-01
1 800 670 0707 (toll free North America) 1 408 987 6030 (direct) +34 93.433.8350 (Europe) 1 800 994 7828 (toll free North America) 1 604 422 2756 (direct) +34 93.433.8351 (Europe)
[email protected] Web: www.xantrex.com
976-0212-01-01