Preview only show first 10 pages with watermark. For full document please download

S1012 3000 – 6000 Mhz / 10 Watts

   EMBED

Share

Transcript

S1012 3000 – 6000 MHz / 10 Watts Key Feature        Solid-state Class AB linear design Instantaneous ultra broadband Small and lightweight Built in control, monitoring & protection circuits Suitable for CW, AM, and FM 50 ohm input/output impedance High reliability and ruggedness ELECTRICAL SPECIFICATIONS @ +28 VDC, 25C, 50  System Parameter Symbol Operating Frequency BW Power Output CW PSAT Output Power @ 1 dB Gain Compression Point P1dB Small Signal Gain GSS Input Power for Rated Pout PIN Gain Flatness G Input Return Loss S11 Noise Figure NF Third Order Intercept Point IP3 2-Tone @ 28dBm/Tone. 250kHz Spacing Harmonics @ rated P1dB G.C.P H Spurious Signals Spur Blanking Response Time TON/OFF Gain @ Blanking Gmute Operating Voltage VDC Current Consumption @ rated Pout IDD MECHANICAL SPECIFICATIONS Parameter Dimensions RF Connectors In/Out DC / Control Connector ENVIRONMENTAL CHARACTERISTICS Parameter Operating Case Temperature Storage Temperature Relative humidity (non-condensing) PROTECTIONS Input RF drive level without damage Load VSWR @ rated output power Thermal Overload Ph. 82 (032) 670-8510~2 Fax. 82 (032) 670-8513 Specifications 3000-6000MHz 10W Min. 5W Min. 45dB Min. 0dBm Typ. ±1.5dB Max. -14dB Max. 10dB Max. Unit MHz Watt Watt dB dBm dB dB dB +46dBm Min. dBm -15dBc Max. -60dBc Max. 5µs Max. -30dB Max. 28V Typ. 3.2A Max. dBc dBc µSec dB Volt Amp Value Type-SMA, Female Dsub, 9-Pins, Male Symbol Tc Tstg RH Specifications -20 ~ +70 -40 ~ +85 ~ 95 Unit °C °C % +10 dBm  @ all load phase & amplitude for duration of 1minute 3:1 @ all load phase & amplitude continuous Graceful Degradation www.RFzone.com Rev. 1.0 / 07-05-2014 S1012 3000 – 6000 MHz / 10 Watts INTERFACE CONNECTOR - D-Sub, 9 Pin Description Pin # Specifications 1 Spare 2 Current Monitor 3 4 Temp Sense Analog voltage relative to Module’s Temperature @ 10mV/°C Spare 5 Shutdown No Connection Amplifier Enable: “Low” or Open Amplifier Disable: “High” (Default) +28.0VDC Ground 6, 7 8, 9 VDD GND Ph. 82 (032) 670-8510~2 Fax. 82 (032) 670-8513 No Connection Analog voltage relative to IP@25mV / 100mA(no load) IP@20mV / 100mA(100kOhm load) www.RFzone.com Rev. 1.0 / 07-05-2014