Preview only show first 10 pages with watermark. For full document please download

Safety Prisms Pdf | 675 Ko | 14/09/2011

   EMBED

Share

Transcript

Safety Prisms You can easily adapt the width, position and energy of the infrared curtains by using one of our various prisms. Make sure both the total width of the door opening and the total height of the closing edge are covered. Always test the good functioning of the installation before leaving the premises. STANDARD The ACTIV8 and the IRIS sensors for sliding doors are both equipped with two standard prisms: 2m H H 2.20 m 2.50 m 3.00 m W 2.35 m 2.50 m 2.70 m W The energy is divided over 2 rows of 24 spots each. 1m H H 2.20 m 2.50 m 3.00 m W 1.35 m 1.50 m 1.70 m W The energy is divided over 2 rows of 12 spots each and therefore more intensive. OTHER 1 M PRISMS Furthermore, there are specially designed, so called masked prisms to adapt the detection field to your specific needs (sold individually). Caution: Do not mask the prisms yourself. This could lead to unsafe door installations. 1 m centre Suited for highly reflective environments. The energy is divided over 2 rows of 12 spots each, but less powerfull because of the masking stickers. 1 m left 1 m right ENGLISH ACTIV8-IRIS COMBINED 1M / 0.5 M PRISMS 1 m left / 0.5 m right XL PRISM 2.6 m 1 m right / 0.5 m left This prism does not allow DIN 18650-conformity. The IRIS ON C sensor for revolving or sliding doors is equipped with a 0.5 m left high and a 0.5 m right high prism: 0.5 M PRISMS IRIS ON C REV IRIS ON C SL 0.5 m left high 0.5 m left Suited for highly reflective environments. Max. recommended mounting height: 2.7 m 0.5 m right high 0.5 m right ©BEA | Application Note | 42.8722 / V1 - 02.11 Suited for highly reflective environments. Max. recommended mounting height: 2.7 m «click» Always make sure to insert the prism correctly into the guiding grooves in the base of the sensor and not in the sensor cover. It is recommended to clean the prisms and optical parts of the sensor at least once a year (or more often if required due to environmental conditions). The width of the detection field depends on the mounting height. All dimensions specified in this document are measured at a mounting height of approx. 2 m. The prisms allow DIN 18650 conformity up to a mounting height of 3 m, unless specified otherwise. BEA SA | LIEGE Science Park | ALLÉE DES NOISETIERS 5 - 4031 ANGLEUR [BELGIUM] | T +32 4 361 65 65 | F +32 4 361 28 58 | [email protected] | WWW.BEA.BE