Transcript
CAUTIONS
• • • • • • • • • • • • • • • • • • • • • • • • • • •
Check that the electrical supply ratings of the appliance are correct for your home (see specification). The induction hob must be connected via an earthed socket, which should have an individually rated load of above 10A. The plug must be fully pushed into the socket. Overheating could occur if a socket is shared and overloaded. PERSONS WITH PACEMAKERS SHOULD KEEP A MINIMUM DISTANCE OF 60CM FROM INDUCTION HOBS - SEEK THE ADVICE OF A DOCTOR. Do not insert plug with wet hands. Do not operate this device using a timer/controller, or remote control system. Do not place the hob near a hot gas or electric burner, or in a heated oven. Do not use the hob in high humidity conditions. The hob should be placed on a level stable worktop at least 10cm from walls or other solid obstructions. Do not use the induction hob on a metal table. Do not use the induction hob on a carpet or tablecloth - the air circulation fan ports are underneath the hob, and could become blocked with fibres. Do not move the induction hob whilst in operation. Never move the hob by pulling the power cord. Ensure that the power cord does not trail over the edge of the worktop, and that it is kept away from any hot object. Do not operate the appliance if the power cord has been damaged: contact STELLAR at the address given. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Always keep the appliance out of the reach of children. The Hob Plate may remain hot for a short period after cooking. Never use the appliance if it has been dropped, shows damage or does not function properly: contact STELLAR at the address given. Do not attempt to repair the induction hob yourself. Use the appliance only for its intended purpose. Extreme caution must be used when moving pans containing hot oil or other hot liquids. Do not heat empty pans, as bases may distort and become ineffective for future use. Keep the unit clean and prevent foreign matter from entering the air circulation ports. Do not immerse the appliance in water. Do not place the induction hob close to devices or objects which are sensitive to magnetic fields - radios, TVs, recording devices, credit cards etc. Do not leave ‘out of use’ cookware on the hob plate - this will become hot if the hob is inadvertently switched on. The hob plate is temperature resistant glass. If it has been damaged in any way, even if the damage is minor, do not operate the unit: contact STELLAR at the address given. Do not attempt to insert wires or tools into the air circulation ports, as this could
Page 5
Induction Hob
•
lead to electric shock. Do not heat unopened tins on the induction hob as they could explode.
SPECIFICATIONS
• • •
Portable Touch Control
Power Supply: 220-240V 50Hz-60Hz Wattage: 2000W maximum Temperature range: 40°C - 220°C
AFTER SALES SERVICE Do not attempt to repair any part of this Hob. Please refer any problem to STELLAR Customer Services.
WARRANTY The STELLAR warranty covers the product to be free of defects in materials and workmanship for period of two years from the date of original retail purchase. During this period, STELLAR will, at our option, repair or replace defective parts of the product, or replace the product, providing the Use Care & Safety Instructions have been followed. The warranty does not cover damage, defect or failure caused by or resulting from accidents, external damage, alteration, modification, abuse, misuse or misapplication. The Hob is for Domestic Use only. The warranty does not cover any damage caused by taking the appliance apart yourself, or attempting to repair the appliance yourself. Please keep your purchase receipt and contact us directly if you encounter any problems with your product. STELLAR CUSTOMER SERVICES HORWOOD AVONMOUTH WAY BRISTOL BS11 9HX GREAT BRITAIN
[email protected] www.stellarcookware.co.uk Tel: 0117 940 0000
Induction Hob Instruction Manual Model No. SEA15
HORWOOD SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT (INCLUDING COLOUR FADING, SCRATCHES OR ACCUMULATED DIRT THROUGH COMMERCIAL USE) WITHOUT FOLLOWING THE USE, CARE & SAFETY ADVICE.
FOR DOMESTIC USE ONLY
CORRECT DISPOSAL OF THIS PRODUCT This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
Page 6
Induction Hob
Please read this instruction manual carefully before use and retain for later reference. www.stellarcookware.co.uk
Unpack your Induction Hob carefully and remove packing pieces. Induction Hob
Page 1
2. Add contents for heating to suitable cookware and place within the centre of the heating zone 2 .
IDENTIFYING THE PARTS 3 5 4 5 2
1
Hob plate Heating zone Mains plug
6
7
8
9
10
11
12
A “beep” will sound and the Display 9 will flash “----”, to indicate that the hob is and controls are enabled. If no further action is taken in Standby; only the within 1 minute, the hob will drop out of Standby, with just the Power indicator illuminated. Note: if any control is touched when enabled, a “beep” will sound to confirm operation of the control.
•
Mains lead Air circulation ports
9. 10. 11. 12.
control; the hob will begin heating immediately in Power mode, indicated by the POWER symbol on the Display 9 , which will also show 1200W, the default power setting.
Multifunction display Up control
1. Touch the
control to display the cooking time, which will start at a setting of 0 minutes, shown on the Display 9 along with a flashing TIMER symbol, which indicates that the time may be set using the and controls, to decrease or increase the cooking time. When setting the time, if either of these controls are held, the setting will count down or up automatically until released.
•
Power control
Min 500W
An induction hob heats in a unique way. A very strong magnetic field is created by electricity running through an electrical coil positioned under a ceramic plate. The ‘induction current’, created by the magnetic field, generates heat in any cookware capable of being magnetised, while standing on the ceramic plate. Only the pan is heated - the ceramic plate remains relatively cool. As a result, spilt food will not burn on to the surface, and can be simply wiped off at the end of cooking.
HOW TO USE Main Cooking Functions 1. Insert the Mains Plug 3 into a mains socket and switch on at the socket. A “beep”
900W
1000W
1100W
Max
1200W 1400W 1500W 1600W 1800W 2000W
6. To select Temperature mode from Power mode, touch the control once. The Display 9 will show the symbol, as well as 120°C, the default temperature setting.
7. Use the
and controls to decrease, or subsequently increase, the required temperature. The following temperature settings are available:
CHOOSING COOKWARE FOR INDUCTION HOB USE Only pans that can be magnetised can be used on induction hobs. Most recent Judge, Stellar, and Horwood cookware is induction-ready, and is described as ‘suitable for all hob types’. Some cookware, although made of non-magnetic material, has a special base which allows efficient working on induction hobs. A simple way to check - if a fridge magnet will stick to the base of the pans, then the pan will heat on an induction hob. Pans with a base diameter of less than 120mm may not work on this hob. Ensure all cookware used on the hob is clean before use.
Default
Min 40°C
•
Default 60°C
80°C
100°C
120°C
Max 140°C
160°C
200°C
220°C
After setting either Temperature or Power, you may subsequently adjust these further, using the and controls. If you wish to make alternative settings, control again, to return to the start point, the default Power setting. touch the Once cooking has started, you may use the Timing and Lock functions - refer to the following headings.
8. When you have finished cooking, touch the
control to switch OFF, wait until you hear the cooling fan stop, then disconnect from the mains.
control will illuminate, to indicate that
Induction Hob
180°C
Page 3
Induction Hob
control to change all settings, or the
control to switch OFF.
•
When the set cooking time is reached, the hob will switch OFF, a series of “beeps” will sound and the display will flash “----”, to indicate that the hob is in Standby.
Lock
•
and controls to decrease or increase the required power. The following power settings are available:
and indicator
Once no further adjustments are made to the time, initially the Display 9 will show the selected Power or Temperature setting, then alternate with the time remaining until the hob switches OFF automatically.
2. To cancel the Timer at any time, touch the
5. Use the
Select control
HOW INDUCTION HOBS WORK
will sound and the indicator above the power is applied.
Cooking may be controlled in either Power mode or Temperature mode; each mode is selected in turn using the control. In Temperature mode, the desired temperature will be reached as quickly as possible and then maintained; this is useful to prevent food burning. In Power mode, the hob will work in a similar way to a conventional hob.
Once Power or Temperature have been set, you may choose to set a cooking time, after which the hob will switch OFF, up to a maximum of 180 minutes.
4. Touch the
Touch Controls & Indicators 6. Lock control 7. Timer control 8. Down control
Page 2
control.
•
5
1. 2. 3. 4. 5.
3. Touch the
Timing
To prevent further operation of the controls during cooking, touch and hold the symbol and all other controls except control. The Display 9 will show the control will be disabled. To switch the Lock OFF, touch and hold the the control again for 1 second, to enable the other controls.
Note: the Lock function cannot be used to prevent operation from Standby. Disconnect from the mains to prevent unwanted use.
CLEANING
•
Clean after each use.
1. Switch OFF, allow to cool and disconnect from the mains before cleaning. 2. Hob Plate: Clean with a warm damp cloth and washing-up detergent, occasionally a proprietary Hob Cleaner.
3. Casing: Clean with a warm damp cloth and washing-up detergent. 4. Air Circulation Ports: Use a vacuum cleaner to suck out dust.
•
DO NOT immerse the Induction Hob in water.
ERROR MESSAGES If shown on the Display 9 , perform the action described below. If this does not rectify the problem, or it repeats without obvious cause, or another error message is displayed, please report the following error messages to STELLAR Customer Services at the address given in the warranty section: • E0: Cookware not present, unsuitable material, or less than 12cm diameter; hob switches power off and “beeps” - use correct cookware. • E1, E2 or E3: Overheating problem; hob switches power off and “beeps” - switch off, remove cookware and allow 5 minutes to cool, check the position and location of the hob, then operate as normal. Page 4
Induction Hob
