Preview only show first 10 pages with watermark. For full document please download

Security Door Controls Main System On

   EMBED

Share

Transcript

SECURITY DOOR CONTROLS 3580 Willow Lane, Westlake Village, CA 91361-4921 (805) 494-0622 • Fax: (805) 494-8861 www.sdcsecurity.com • E-mail: [email protected] REGULATED POWER SUPPLY INSTALLATION INSTRUCTIONS MODEL 636RF FIGURE A COMPONENT LOCATIONS AC INPUT: GRN – GROUND WHT – NEUTRAL BLK - HOT AC INPUT CIRCUIT BREAKER FIGURE B CONTROL MODULE CONTROL MODULE CONTROL MODULE CONTROL MODULE POWER SUPPLY BOARD BATTERY 1 7ah BATTERY 1 7ah STANDARD BOX CLASS 2 OUTPUTS 6 AMP OUTPUT AUXILIARY RELAY CONNECTION SYSTEM STATUS LED 2A + 2A + 2A + MAIN SYSTEM ON-OFF FIGURE C Master ON/OFF Switch (N/C) _+ MAIN C + _ C MANUAL RESET Min. Switch or Contact Ratings 100mA @ 30VDC VOLTAGE SELECT + BATTERY LED STATUS LEGEND: YELLOW – SYSTEM OK RED – NO AC INPUT GREEN – NO DC OUTPUT _ BATTERY INPUT TERMINALS 24V 12V 24V POSITION 12V POSITION POWER SUPPLY SPECIFICATIONS Input Voltage: 115 VAC @ 60hz Input Current: 1.8 amps Max. Output Voltage: 12/24VDC (Regulated) Output Current: 6 amps Ripple Voltage: 0.05 Volts Max. VOLTAGE SELECTION NOTE: POWER MUST BE TURNED OFF BEFORE CHANGING VOLTAGE 12 Volt Mode Battery Connections SWITCH SET FOR 24VDC SWITCH SET FOR 12VDC Battery Charger Max. Current: 0.35 amps Maximum recommended battery size: 7 ah (Replace batteries every 3 years) Suitable Uses: Electric Lock Power Supply Access Control Power Supply 24 Volt Mode Battery Connections + + _ + _ _ + 12VDC TEST UNIT YEARLY P:\INSTALLATION INST\Power Supplies\INST-636RF\INST-636RF.VSD Rev F 06-06 _ 12VDC + _ 12VDC