Transcript
SFP+ 10G SR Part no: 70287-xx
Features
Applications
Optical interface compliant to IEEE 802.3ae 10GBASE
10GBASE- at 10.3125Gbps
Electrical interface compliant to SFF-8431
10GBASE- at 9.953Gbps
Hot Pluggable
Other optical links
850nm VCSEL transmitter, PIN photo-detector
Operating case temperature: 0 to 70 °C
Low power consumption
Applicable for 300m MMF connection
All-metal housing for superior EMI performance
Advanced firmware allow customer system encryption information to be stored in transceiver
Cost effective SFP+ solution, enables higher port densities and greater bandwidth
Electrical characteristics The following electrical characteristics are defined over the Recommended Operating Environment unless otherwise specified. Parameter
Symbol
Min.
Typical
Max
Unit
Data Rate
-
10.3125
-
Gbps
Power Consumption
-
600
800
mW
Notes
Transmitter Single Ended Output Voltage Tolerance
-0.3
-
4.0
V
C common mode voltage tolerance
15
-
-
mV
Tx Input Diff Voltage
VI
90
350
mV
Tx Fault
VoL
-0.3
0.4
V
Data Dependent Input Jitter
DDJ
0.10
UI
Data Input Total Jitter
TJ
0.28
UI
4.0
V
425
mV
At 0.7mA
Receiver Single Ended Output Voltage Tolerance
-0.3
-
Rx Output Diff Voltage
Vo
150
Rx Output Rise and Fall Time
Tr/Tf
30
Total Jitter
TJ
0.70
UI
Deterministic Jitter
DJ
0.42
UI
Hexatronic AB Exportgatan 47B SE-422 46 Hisings Backa
ps
Fax. +46 (0)31-58 59 30 Tel. +46 (0)31-742 53 30 Tel. +46 (0)8-96 76 80
20% to 80%
[email protected] www.hexatronic.se
SFP+ 10G SR Part no: 70287-xx
Optical characteristics The following optical characteristics are defined over the Recommended Operating Environment unless otherwise specified. Unit
Values
m
2 - 10K
Cen ter w avelength (range)
nm
1260 -1355
Side Mode Suppression Ratio (min)
Operating Reach Transmit
Launched power – maximum (Averag e)
dB
30
dBm
+0.5
– minimum (Average)
dBm
− OMA
dBm
-5.2
− OMA-TDP (min )
dBm
-6.2
Transmitter an d dispersio n penalty (ma x) Average launch pow er o f OFF transmitte r (max) E xtinction ratio (min)
-8 .2
dB
3.2
dBm
-30
dB
RIN12 OMA (max) Optical Return Loss Tolerance (min)
No tes1
3 .5
Notes2
dB/Hz
-128
dB
12
nm
1260-1355
Receiver Cen ter w avelength (range) Receive overload (max) in average power1 Receive sensitivity (min) in average power1
dBm
0.5
dBm
-14.4
Notes3
Receiver sensitivity (max) in OMA (footnote 2)
dBm
-12.6
Notes3
Rec eiver R eflec tance (m ax) Stressed receiver sensitivity (max) in OMA2 Vertical eye closure penalty (min)3
dB
-12
dBm
-10 .3
dB
2.2
Stressed eye jitter (min)2
U Ip -p
0.7
Rec eive elec tric al 3dB upp er cuto ff frequ enc y (max)
GH z
12.3
Rec eiver p ow er (damage, Max)
dBm
1.5
Notes: 1. 2. 3.
The optical power is launched into SMF 31 Measured with a PRBS 2 -1 test
[email protected] Measured with a PRBS 2 31-1 test
[email protected] BE
Hexatronic AB Exportgatan 47B SE-422 46 Hisings Backa
Fax. +46 (0)31-58 59 30 Tel. +46 (0)31-742 53 30 Tel. +46 (0)8-96 76 80
[email protected] www.hexatronic.se
SFP+ 10G SR Part no: 70287-xx
Absolute maximum rating These values represent the damage threshold of the module. Stress in excess of any of the individual Absolute Maximum Ratings can cause immediate catastrophic damage to the module even if all other parameters are within Recommended Operating Conditions. Parameters
Symbol
Min.
Max.
Unit
Power Supply Voltage
V CC
0
+3.6
V
Storage Temperature
Tc
-40
+85
°C
Operating Case Temperature
Tc
0
+70
°C
Relative Humidity
RH
5
95
%
RX Input Average Power
Pmax
-
0
dBm
Recommended operating environment Recommended Operating Environment specifies parameters for which the electrical and optical characteristics hold unless otherwise noted.
Parameter
Symbol
Min.
Typical
Max
Unit
Power Supply Voltage
VCC
3.135
3.300
3.465
V
Operating Case Temperature
TC
0
25
70
°C
Hexatronic AB Exportgatan 47B SE-422 46 Hisings Backa
Fax. +46 (0)31-58 59 30 Tel. +46 (0)31-742 53 30 Tel. +46 (0)8-96 76 80
[email protected] www.hexatronic.se
