Transcript
Models: PAP 176, PAP 176-S, PAP 176-W
Installation and Assembly - Projector Adapter Plate for Toshiba™ model TLP-S30U Projector
WARNING
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
• Installer must verify that the ceiling will safely support four times the combined weight of all attached equipment and hardware.
Before you start check the parts list below to make sure all of the parts shown are included.
AA
Parts List Description AA BB CC DD EE FF
adapter plate M4 x .7 x 20 mm thumb screw retaining spacer M4 x 10 mm serrated washer head socket pin screw .16" thick plastic spacer 4 mm security allen wrench (for PAP only)
Qty.
PAP 176
PAP 176-S PAP 176-W
1 1 1 2 2 1
055-1324 560-1137 590-2020 510-1060 540-9455 560-9646
055-4324 560-7137 590-2009 510-2060 590-0108 560-9646
055-2324 560-7137 590-2009 510-2060 590-0108 560-9646
Note: Actual parts may appear slightly different than illustrated.
BB EE
CC
DD
FF
*Notch indicates front of projector. Place retaining spacer (CC) on remaining hole on projector. Then close adapter plate (AA) and fasten with thumb screw (BB).
Flip projector upside down. Fasten adapter plate (AA) using two spacers (EE) and two M4 x 10 mm serrated washer head socket pin screws (DD) indicated below. Tighten screws using security allen wrench (FF).
AA BB
AA DD DD
*
Spacers (EE) go between adapter plate and projector.
Retaining spacer (CC) goes between adapter plate and projector.
1 of 1 Visit the Peerless Web Site at www.peerlessindustries.com © 2004 Peerless Industries, Inc. All rights reserved. Peerless is a registered trademark of Peerless Industries, Inc. All other brand and product names are trademarks or registered trademarks of their respective owners.
ISSUED: 01-24-03 SHEET #: 055-9144-4 08-09-04
For customer service call 1-800-729-0307 or 708-865-8870.
