Transcript
Code / Ref. Nr.:
530219
Date:
November 2008
Subject:
Tilting on FS40-55
WARNING: • • • • • • • •
•
Carry out the handling according to the following manufacturer’s instructions. Always respect warnings from the relevant manuals of the machine. Make sure all electric power or other energy sources are disconnected and closed before any servicing. Always turn off the main switch. Wait 10 minutes after electrical power is disconnected to eliminate power on the inverter terminals. Installation, maintenance and service must be executed by skilled service personnel only or by a service organisation with appropriate authorization from the manufacturer. For service, use only original replacement parts. Re-install all machine parts in the original way. The qualified agency performing this work assumes all responsibility for this kit installation. Other service activities than described below, disable all manufacturers’ responsibility. Make sure children are not around during work in progress.
Primus Belgium Driemasten 126 B-8560 Gullegem Belgium Phone: +32 (0)56 43 52 00 Fax: +32 (0)56 40 34 63 E-mail:
[email protected] Web: www.primuslaundry.com
Primus Central Europe Mistecká 1116 742 58, Příbor Czech Republic Phone:+420 556 768 800 Fax: +420 556 723 383 E-mail:
[email protected] Web: www.primuslaundry.com
Primus France Rue Jacques Monod z.i. Est F-69120 Vaulx-en-Velin France Phone:+33 (0)4 78 79 55 75 Fax: +33 (0)4 72 04 62 72 E-mail:
[email protected] Web: www.primuslaundry.com
Washer
Applicable machine models Dryer
Ironer
PW5
DAM5 / DAMC5
Pony
P6, P7
DA9 / DAM(S)(T)9
I18, 25, 30
C6, 8
T9
I35
RS6, 7, 10
T11, 13, 16
I50
RS13, (16), 18, 22, 27, 35
T1313
IR50
FS6, 7, 10
T24, 35
IF50
FS16, 22, 23
DA11, 13, 15
IFF
FS33, 40, 55
DA1313
Crossfolder
FS120
D25, 35
Stacker
MB16, 26, 33
D55, 77
MB44, 66 MB90, 140, 180 XS22 XS35, 43
Washer
Applicable type of spare parts Dryer
Ironer
General
General
General
Chasis
Chasis
Chasis
Shock absorbers
Cabinet
Cabinet
Cabinet
Controler
Controler
Controler
Coin unit
Coin unit
Coin unit
Electric components & sensors
Electric components & sensors
Electric components & sensors
Heating unit
Heating unit
Heating unit
Motor & pulley & belts
Inlet
Inlet
Bearing house & seals
Motor & pulley & chains
Soap hopper
Drum
Bearing house
Motor & pulley & belts
Door
Ironer belts
Bearing house & seals
Air filter
Air filter
Drum
Air fan
Air fan
Door
Exhaust
Exhaust
Drain
Delivery system Folding system
Page 2 of 3
Code / Ref. Nr: 530219
A tilting device for FS40/55 washers was introduced. The device can be ordered as an option when FS40/55 machine is ordered or as a standalone device, which can be attached to an FS40/55 washer in the field. The only condition is that the machine must be equipped with the MCG FC control (Graphitronic). The tilting device allows the user to tilt the washer up to 17 degrees to the front for easier unloading. Door is equipped with a door block which prevents the door from closing when the machine is tilted. Ordering codes of standalone tilting devices are 529436 (FS55) and 526439 (FS40).
In case you have further technical questions, do not hesitate to take contact with the after sales department of PRIMUS (references at the front page of this document).
Page 3 of 3
Code / Ref. Nr: 530219
