Transcript
HOW TO ASSEMBLE YOUR SCOPE:
ANCHOR MASTER 36 Power, 90080 Telescope
Before, you begin to assemble your scope, you will need to have a Phillips-head screwdriver and a Crescent wrench. *NOTE* Please be careful not to scratch your scope.
**IMPORTANT** NEVER ATTEMPT TO CLEAN YOUR SCOPE INTERNALLY OR TRY TO TAKE IT APART. DO NOT LOOK DIRECTLY AT THE SUN WITH THE SCOPE AS IT WILL CAUSE DAMAGE TO YOUR EYE.
1
1. Place the optical tube and arc mount on its side. 2. Attach the legs of the tripod at the base of the mount. 3. Carefully slide one of the leg attachments shaft through the top of the attached leg through the holes of the mount. Make sure that the support tray brackets are facing up. 4. Gently stand the scope and tripod, slowly spread the legs of the tripod. 5. With the shining side of the support tray facing up, screw in its brackets.
8
5
Make sure to tighten all screws and nuts. Your scope is now assembled and ready to be used. 6 7
2
4 3
9
HOW TO MOUNT THE FINDER SCOPE 1. Attach the 2 mounting rings to the optical tube with 4 mounting screws. 2. Center the finder scope within the mounting rings using 6 mounting screws
HOW TO USE YOU SCOPE: Start by loosening the lock and levers and gently guide the scope to your desired position. 1. Once it’s at the position that you want, tighten the locks and levers. 2. Point the objective lens to an object and look through the eyepiece. 3. With slow and tiny motions, rotate the focus knob slowly, until your view of the object is sharp and in focus.
HOW TO TAKE CARE OF YOUR SCOPE:
PARTS 1. Optical tube with arc mount attached 2. Mahogany wood tripod 3. Support tray 4. Lock and levers 5. Objective Lens 6. Eyepiece 7. Focus Knob 8. Finder Scope 9. Image diagonal
1. When wiping the lenses, use a soft lens cloth. 2. To remove any remaining dirt or smudges, add one or two drops of isopropyl alcohol to the cloth, then wipe gently. 3. Store your scope in a moisture-free area.
Parts included in package: Optical tube with mount attached Mahogany wood tripod legs Acorn nuts Support tray Washers and bolts Mounting Screws Mounting Rings
1 unit 3 units 3 pcs 1 unit 3 sets 10 pcs 2 pcs
