Transcript
6
5 REVISION HISTORY DESCRIPTION DATE ECO-01358 2/5/2004 ECO-01378 3/29/2004 ECO-02527 4/8/2009
REV 0 1 2
4
3
APPROVED WSS WSS WSS
2 2
ITEM 1 2 3
PART NUMBER FMSBKTRX100 FMSBKTLX100 SCR1032X1/2BLK
2 Bill of Material QTY DESCRIPTION 1 FRONT MOUNTSUPPORT BRACKET - RIGHT HAND 1 FRONT MOUNT SUPPORT BRACKET - LEFT HAND VERSION 4 #10-32 x 1/2"L PAN HEAD PHIL TYPE 23 (NOT INCLUDED)
1 FILE NAME I002055.iam I002054.iam SCR1032X500BLK.ipt
REV 1 1 -
FRONT MOUNT EIA EQUIPMENT D
D
2 3
THIS BRACKET SET GIVES SUPPORT TO ANY EIA EQUIPMENT WITHOUT INTERFERING WITH THE EQUIPMENT OR USING ANY OTHER VERTICAL EIA SPACING.
3 3
WORKS ON ANY EIA MOUNTING!
2 3 C
C
1
MOUNT THEM WITHIN AN ENCLOSURE TO PROVIDE SUPPORT / MOUNTING FOR EQUIPMENT THAT REQUIRES 3/8" SQUARE HOLES WHEN YOU HAVE THREADED HOLES.
B
B
NOTE: 1.) MOUNT THE SUPPORT BRACKET SO THAT THE SUPPORT SURFACE EXTENDS OFF THE FRONT MOUNTING SURFACE OF THE EIA RACK OR MOUNTING RAILS. 2.) ONE BRACKET SET WILL SUPPORT UP TO 125 lbs. OF EQUIPMENT OF 17.5" WIDTH (NO LESS). WEIGHT MUST BE EQUALLY DISTRIBUTED AMONG ALL FOUR SUPPORT BRACKETS.
INTERPRET DRAWING PER ASME Y14.5M-1994 DIMENSIONAL LIMITS APPLY AFTER APPLICATION OF FINISH
A
DRAWING NOT TO SCALE
TOLERANCE UNLESS OTHERWISE NOTED: ANGULAR +/- 1 .XXXX +/- .010 .XXX +/- .015 .XX +/- .030 .X FOR REF. ONLY
THIRD ANGLE PROJECTION
6
5
UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE IN INCHES
4
NOTICE:
PART NUMBER:
RCT-SRRRNSK
Use of this document is subject to QTY PER UNIT: 1 MATERIAL TYPE: a confidentiality and nondisclosure agreement with Rackit Technology MATERIAL GAUGE: Corporation (Rackit) and may FINISH: not be reproduced, disclosed or utilized in whole or in part without DRAWN DATE 2/5/2004 prior written authorization from Rackit. WSS CHECKED & APP.
J.A.L.
3
DATE
2/5/04
2
TITLE
Rear-Mount Support Kit A
Rackit Technology Corporation 271 Madison Avenue, New York NY 10016 PHONE (212) 679-0050 FAX (212) 679-0040 E-MAIL
[email protected] DWG NO:
I002053
REV
2
SHEET: 1 OF 1 1
