Transcript
Radio Transmitter Setup & Operation
Ness-Takex Radio PIRs
Radio Transmitter setup and operation Rev 2. Refer to the separate Takex manual for installation and setup of the sensors. Product Models
TX-103R Outdoor Radio PIR TX-114R Outdoor Radio PIR
NESS Radio Features • Transmits Ness 56 bit encrypted format. • SUPERVISORY messages sent hourly. • LOW BATTERY detection and transmission. • Ultra low current draw. • Alarm, Low Battery and Supervision messages (Both models). • Tamper message (TX-114R only). TAKEX SENSOR FEATURES
TX-103R
• Outdoor Radio PIR. TX-114R
• Pet Tolerant to 18kg (TX-114R). • Pointable through 180 degrees. • Adjustable sensitivity & pulse count. • Adjustable lux level sensor for day and/or night operation selectable. • 9V battery operation.
Introduction This manual covers the setup and operation of the Ness Radio Transmitter fitted to the TX-103R and TX-114R Radio PIRs. For instructions on the installation and adjustment of the motion sensors, refer to the Takex documentation supplied with each unit. The Ness Radio Transmitter is factory-fitted inside the sensor and requires no installation or adjustment. The Ness Radio Transmitter is compatible with all Ness receivers and radioenabled control panels. Radio security features include radio encryption and an hourly supervision signal for enhanced radio security when used with Ness control panels. “Another innovative Ness radio product.”
TX-103R
TX-114R
Battery holder
Transmitter (internal)
Transmitter & battery holder
Radio Transmitter Alarm Signals The sensor sends an alarm signal when it alarms and a restoral signal when the alarm resets. A supervision signal is sent every hour. The supervision message can be used by compatible control panels to verify the correct operation of the sensor. A Tamper alarm is sent by the TX-114R model. (The TX-103R does not send Tamper). Programming To a Receiver The transmitter sends a radio learn message on power up, (when you connect the battery). For programming to a Ness control panel or standalone receiver refer to the manuals for those products. Battery A single 9V battery powers the sensor and the radio transmitter. A low battery signal is sent when the battery is low and should be replaced. The battery status is sent every hour along with the supervision message. Compatible Ness receivers and control panels can display low battery and supervisory alert warnings. Transmitter Timeout Both sensors have a selectable Prohibition Timer to conserve battery life. When the Prohibition Timer is enabled, the sensor will not re-transmit for a set period after an alarm. TX-103R
TX-114R
Prohibition Timer has two settings, ON (1min) and OFF.
Prohibition Timer has 4 settings, 10sec, 120sec, 300sec, 900sec.
Prohibition Timer Dipswitches 2 & 3 Prohibition Timer switch
Radio Transmitter Specifications LED Indicator (TX-114R only)
One flash for each radio message transmitted. Fast flash every 2.3 seconds for a low battery condition while the lockout timer is operating. One flash for each block of data while transmitting code in learn mode Continuous fast flash for error condition
Signals Transmitted
Alarm. Low Battery. Supervision (hourly). Tamper (TX-114R only).
Operating voltage
9V Lithium battery.
Current draw
Standby, 5µA Alarm, 4mA
Radio Transmitter Type
SAWR stabilised.
Radio Frequency
304MHz, 868MHz, 434MHz available for various world markets.
Radio Compatibility
All Ness radio receivers. All Ness control panels with radio options fitted.
Operating Temperature
-20°C to +50°C
Ness Transmitter
Ness-TAKEX Radio PIR Setup & Operation Notes Revision 2 Document Part Number 890-398
Copyright Notice All rights reserved. No part of this publication may be reproduced, transmitted or stored in a retrieval system in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Ness. Ness reserves the right to make changes to features and specifications at any time without prior notification in the interest of ongoing product development and improvement. © 2010 Ness Security Products Pty Ltd ABN 28 069 984 372
