Transcript
Instruction Manual GRX-1200-R
Your Cart-Tek golf caddy was thoroughly quality control checked and road tested before being shipped to your address. We do everything possible to assure that your cart is in perfect working order upon arrival. Should you have any issues or questions about the performance or your cart, please email us at
[email protected] or call Toll Free 1-866-356-CART (2278)
BASIC SETSET-UP
Remove all components form carton. Note any damage with carrier. Assemble the two large wheels. Depress blade on wheel hub to fully seat wheel onto axle drive pins. Depress and pull wheel out ¼ “ to “free wheel” Lift handle and secure with lower locking knob Extend handle fully and secure in position by lowering the “upper bag rest” Place battery in tray and use small block of wood to hold battery “forward” in the tray. Attach power cable, making sure to align pins. Depress lock before removing cable. Attach rear “anti-tip” wheel Load golf bag onto caddy. Attach bag straps using the metal latches Attach antenna to command center. There are two spare fused packed with your cart. You should carry these in your golf bag. In case of ‘power loss’, check the fuse in the battery case first.
1.) Lift handle into upright position
2.) Lower locking knob
3.) Lower upper bag rest to lock handle in position
Manual Mode
When you first connect the battery to the cart, the green LED will flash. This is “Standby” mode
Push and hold on/off button until the green LED is solid
Rotate speed dial clockwise to control speed of cart.
Rotate speed dial counter-clockwise to slow/ stop cart’s motion
1.) Power/ standby LED
2.) Speed Controls
3.) On/off button
a.) when light turns steadily red, caused by the over-voltage. Ways to fix this problem; press Emergency stop on remote or press stop button on receiver b.) when red light is flashing rapidly, caused by over-current. Ways to fix this problem; press emergency stop on remote to stop the cart. When the red light flashes for more then 25 seconds the cart will automatically stop. c.) when red light is flashing slowly caused by high temperature. Ways to fix problem; turn off cart and allow battery to cool down.
Remote Mode
When the green light on the cart is solid and the cart is stationary, your cart is ready for remote control transmission. Push forward or reverse function buttons to move the cart. By pressing and holding Left or Right turn, the cart will turn “upon” itself. While cart is moving forward, a quick push of Left or Right turn will adjust the cart’s course. To increase the speed. Press forward button. To decrease speed, press the reverse button The range of the transmitter is 80 – 100 yards depending on environmental conditions. However we recommend you stay with 20 30 yards for best control.
Directional Controls: top button moves cart forward Brake: The red button in the middle of the directional controls is to stop your cart. Works in manual mode and remote mode. Cruise Controls: there are factory set; button 1 is the slowest and button 4 is the fastest. Setting Button: Used in programming mode only.
Programming your Remote Transmitter
The red button between the four speed settings is the start/ setting button To adjust tracking (cart trails off to one side or the other, on flat ground) ◦ ◦ ◦ ◦ ◦
To adjust turning force.You can increase or decrease the speed at which the cart turns. ◦ ◦ ◦ ◦ ◦
A. Press and hold Start/ Setting button until LED on Transmitter flashes, the cart will go forward at a slow speed. This is the adjustment mode B. To adjust the caddy to the left, press Left button once. You will not see the cart respond at this point C. To save the setting, push the “Emergency Brake” button D. To adjust the cart to the right, press the Right button as described E. Test the cart to see if you need further adjustment A. Press and hold Start/ Settings button as above B. Press the Forward or Reverse button to stop the caddy. C. To increase the turning power, press the forward button. To test the adjustment press the left or right turn buttons D. To decrease the turning power, press the reverse button. Test as above. E. To save your setting, press the Emergency Brake Button.
To store personal speeds on 1-4, press and hold the desired button while traveling at the desired speed To resume the Factory speed settings, go to “Turning force” adjustments mode as above and press all four buttons. To resume system to Factory settings; go to “Turning force” adjustment mode as above, press speed 1, speed 3, speed 4, speed 2 in order, then press Emergency Brake. The cart is now at factory settings
Programming “New Remote Transmitter”
Should you need to replace your remote transmitter, you will need to program it to your GRX-1200-R
With the cart on ( solid green LED ), plug the USB connector into the port on the cart and the transmitter (see picture below)
Push the Start/Stop button on the cart to put the cart into “Standby” mode. At this time, you will notice the LED on the transmitter will flash quickly. Following this quick clash, count 16 slow clashes of the red LED on the transmitter.
After 16 flashes, press the “Emergency Stop” button
Disconnect the USB cable and return the cart to solid green LED.
Test all remote functions .
Cautions
Before trying to operate your GRX-1200-R, you will need to charge the 12 Volt SLA cart battery overnight.
The USB port on the underside of the receiver Dome can be used to charge your remote transmitter battery. This is an alternative to the wall charger or in case you lose power on the course.
Under normal use, one charge of the transmitter should give you three months service. If you play everyday, you may need to charge your transmitter every 30-45 days.
When first using your cart, practice in a large open area.
You will want to “balance” your cart to keep the front wheel on the ground under normal course conditions. Your GRX-1200-R should only tip onto the rear wheel when on extreme inclines. You may need to add weight to your golf bag to adjust the balance of the cart. Keep battery forward, using the small block provided.
Battery Service
Cart Battery – 12 Volt – 40 Ah • To maximize battery life, charge your cart battery immediately following your round of golf. LED on charger will turn green when battery is fully charged. • During periods of inactivity, charge your battery every 30-45 days. • Store your battery in a cool dark place
Transmitter Battery – Lithium Ion • The operational voltage range on your transmitter is 3.0V to 4.13V • When the voltage falls below 3.2V, the red LED will flash quickly, indicating that your transmitter should be charged • Charge your transmitter using the wall charger supplied. Connect via USB cable. Charge for 12 plus hours. You can charge your transmitter from the USB port on the cart if needed.
