Transcript
AP-GIC-010A(B)-030 PoE Injector Quick Installation Guide P/N: 625028600G INTRODUCTION Model AP-GIC-010A-030 GE AP-GIC-010B-030 GE
Description Standard 802.3at 30W output Passive 30W output. (The PoE output should only be connected to an IP camera. It should not be connected to non-PoE devices, such as a PC's LAN port)
IMPORTANT: The AP-GIC-010B-030 GE does not support the following models: FD8381-EV, IB8381-E, FE8181(V), FE8391 These models come with PoE detection. They will consider the "Passive" injector as an ordinary 802.3af power source, and hence will only draw 15 watts of power from it. 15 watts is insufficient for driving the onboard heater and IR lights. PACKAGE CONTENTS * 1x PoE injector * 1x Quick Installation Guide
* 1x AC power cord
IMPORTANT: 1. Use CAT5 or 5e UTP/STP cables. 2. AC input (100~240V/AC, 50~60Hz), for a max. consumption of 30W. CONNECTION
Non-PoE Switch
PWR PoE
100~240V AC
P+D OUT Data IN
Installation Steps: 1. Connect the included AC power cord to the injector. The Power LED (Green) should be lit. 2. Connect the Data IN port to a LAN switch using an Ethernet cable. 3. Connect the Power+Data OUT port to a powered device, i.e., IP camera, using another Ethernet cable. Make sure the PoE LED (Yellow) is lit. 4. Check if the powered device (IP camera) is working properly. An IP camera may take up to 1 or 2 minutes to power up.
All specifications are subject to change without noice. Copyright © 2014 VIVOTEK INC. All rights reserved.
VIVOTEK INC. 6F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan, R.O.C. |T: +886-2-82455282| F: +886-2-82455532| E:
[email protected]
AP-GIC-010AB-injector_QIG,v1.0_20141210.indd 1
VIVOTEK USA, INC.
VIVOTEK Netherlands B.V.
2050 Ringwood Avenue, San Jose, CA 95131
Busplein 36, 1315KV, Almere, The Netherlands
|T: 408-773-8686| F: 408-773-8298| E:
[email protected]
|T: +31 (0)36 5389 149| F: +31 (0)36 5389 111| E:
[email protected]
2014/12/12 下午 05:45:19
